How do you derestrict a boatian moped?
you don't! you shouldn't buy Chinese motercycles!
Don't listen to him !
I have a boation, under your seat there is the compartment for
your carb, well if you look at where the cable goes round the
little reel type thing there is a little screw simply stopping your
throttle cable pulling as much as it could, 50 % / 70 %, somthing
like that, if your brave take it out, you WILL be impressed.
all of the above is nonsence the way to tune/derestict your
baotian is simple. first you should open the hatch at the bottom of
your seat there you will find the carb remove the cap but be
careful of the spring , remove the rubber seal which should be
attached to a hard piece of plastic with a needle on using a small
screwdriver undo the screw holding in the needle , on top of the
needle there is a small threaded bit with a washer on simply move
the washer up the thread to increase the fuel flux. secondly at the
front of the air box is your air intake tube with a small pipe
coming off of it leading to the exhaust or manifold simply cable
tie the tube to the frame but not to tight this will increase air
intake. thirdly drill ten 4 mm holes on the air box any way you
want this will also increase air intake and acceleration and last
of all the hardest one, remove the belt drive case and using an air
compressor gun remove the nut on the left pulley/variator remove
the variator and behind it should be one or two washers remove one
if ther is two and remove it if there is only one then put your
bike back together take it down a big hill and enjoy speeds of upto
and around 65mph - 70mph with out spending any money.