where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150
According to Haynes Manual, 2001 and later 2.3L Ford Ranger, the Cylinder Head Temperature (CHT) sensor replaces the Engine Coolant Temperature (ECT) sensor on earlier models. The CHT sensor is located between the #2 and #3 spark plugs in the cylinder head and can be accessed through the valve cover. Carefully pull back the CHT cover to expose the electrical connector then disconnect it from the CHT sensor. Unscrew the CHT sensor and remove it. Installation is the reverse of removal, being careful not to overtighten the CHT sensor when installing it.
The CHT sensor is located on the inner wall of the right (passangers side) cylinder head.To access the CHT sensor you must remove the intake manifold
they have ect and cht which is cylinder head temp. the one in the right front of head is the CHT sensor
Change CHT sensor=Cylinder Heat Termo switch
V8 model: The CHT sensor is located on the inner wall of the right cylinder head (passenger side) V6 model: The ECT sensor is located on top of the engine, near the upper radiator hose
Cht.
P0125 - Insufficient Coolant Temperature For Closed Loop Fuel Control Indicates the ECT or CHT sensor has not achieved the required temperature level to enter closed loop operating conditions within a specified amount of time after starting engine. Insufficient warm up time Low engine coolant level Leaking or stuck open thermostat Malfunctioning ECT sensor Malfunctioning CHT sensor Refer to Thermostat Monitor in Section 1, Description and Operation, for system information.
To use cheats you must have a folder named CHT on the root of your SD card. manual create one If not existed. The CHT folder is where all your cheat files will be stored. EZ5 kernel built two cheat engine since ver 1.72, CHT and ARDS. CHT is the EmuCheat format which used widely in Chinese. ARDS is the ActionReplay codes provide by Codejunkies. CHT engine accept single ".cht" file and database "cheatcode.dat" ARDS engine accept database "ezarcode.dat" which created by ardscodeeditor, you can get it on the software download page. You can toggle the cheat engine in the EZ5 system setting.
It depends which engine you have; however, the CHT is a Cylinder Head Temperature, not an ECT (Engine Coolant Temp) and on the Zetec DOHC engined Focus this is on the cylinder head, squeezed behind the alternator where you can't really see it. Most Focuses have a CHT and not an ECT. Ben
Bandarban is the capital of CHT. BANGLADESH.
The Cylinder Head Temperature (CHT) sensor for the 2.3L engine is located between the two center ignition coils. The Engine Coolant Temperature (ECT) sensor for the 3.0L engine is located in the intake manifold to the right of the thermostat housing. The Engine Coolant Temperature (ECT) sensor for the 4.0L engine is located in the intake manifold behind the thermostat housing.