0
What is a drive cycle and how many times it needs to be run to reset test sensors on most cars?
Wiki User
∙ 15y ago
# Cold Start the engine. For Cold Star, the engine coolant temperature must be below 50°C (122°F) and within 6°C (11°F) of the ambient air temperature at startup.
# Idle the engine in drive for two and a half minutes with the A/C and rear defroster on.
# Turn the A/C and rear defrost off, and accelerate to 55 mph (88km/hr) at half throttle.
# Hold at a steady speed of 55 mph (88km/hr) for three minutes.
# Decelerate (coast down) to 20 mph (32km/hr) without braking or depressing the clutch.
# Accelerate back to 55 to 60 mph (88-96) km/hr at ¾ throttle.
# Hold at a steady speed of 55 to 60 mph (88km/hr) for five minutes.
# Decelerate (coast down) to a stop without braking.
For more info look at the related link below.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the Drive cycle 2003 olds alero to reset sensors?
Dan T
How do you reset the obdii drive cycle on 2003 Mercedes Benz e500?
How do you reset a e500 mercedes benz drive cycle
What is the drive cycle to reset 2001 Toyota solara?
what is the drive cycle of Toyota solara 2002
Do you have to operate the sienna after battery replacement to reset the computer?
to reset the old codes you must drive it for atleast an entire drive cycle
How do you reset the drive cycle on the computer of a Honda element?
You take out the battery and reinsert it.
How do you reset all sensors in a 2001 S430?
What sensors??? Tire pressure sensors? You can reset the tire pressure sensors through the instrument cluster
What is the drive cycle for a 1998 dodge stratus?
I have a 1998 dodge stratus and the obd inspection results are showing notcomplete or unsupported. I have been told to drive the car so the computer can reset. What is the drive cycle for this car. I have a 1998 dodge stratus and the obd inspection results are showing notcomplete or unsupported. I have been told to drive the car so the computer can reset. What is the drive cycle for this car.
How do you reset the obd2 drive cycle for 1999 s-10 Chevy?
Disconnect the battery.
How do you reset the traction warning system after you replaced the hub sensors?
If you have made the correct repairs, a short drive will clear the light.
How do you reset the CPU on a 1998 Safari?
There are 2 possible ways to reset the computer, 1. if it doesnt have a "hard" code in it then you can just disconnect the battery wait for 5mins then reconnect the battery. 2. have a repair shop put the OBD tester on it extract the codes (hopefully fix any codes there) then clear the codes this will reset the computer it will take a completed drive cycle to see if the problem returns. In both cases normal driving will take a couple of days to do the drive cycle and to get all the sensors back online.
If i replaced the catalytic converter in a 2001 Toyota solara and reset the engine how long would i need to drive to reset the sensors to pass emissions?
Varies, a couple of weeks should be enough.
What is the drive cycle to reset the computer on a 2002 Toyota 4Runner?
unhook the battery for about a minute or so, then reconnect!
