0
What else can I help you with?
What is a engine block ring do in a model rocket?
A block ring holds the engine firmly in the rocket tube. If not for this, the engine would go up the tube and the rocket would go on fire.
What makes rocket engine mount fit rocket tube?
You wrap tape or a cardboard ring around the engine mount until it fits tightly in the fuselage tube.
Where is the piston ring on a Ford Escort?
On the pistons, in the block. If they are bad, it's time for an engine rebuild.
What is the clearance of piston ring to the block?
There is no clearance of the ring to the block. The ring works in contact with the block to seal the combustion chamber and provide oil control.
Is there a gasket or o-ring for oil filter housing on a 2001 Kia Sportage 2.0l?
yes there are 2 o-ring gaskets against the engine block where the oil filter housing attaches.
What is the ring gap on 8 hp Briggs stratton engine?
The ring gap on an 8 HP Briggs & Stratton engine typically ranges between 0.010 to 0.020 inches (0.25 to 0.51 mm) for the top compression ring. It's essential to check the manufacturer's specifications in the engine's service manual, as the exact gap can vary based on the engine model and intended application. Proper ring gap ensures effective sealing and optimal engine performance.
How do you replace the o-ring that connects to the water pump?
Information needed. What year, make, model, engine size are we working on?
How do you block a user on Skype?
Ring them up and shout BLOCK EGG
Why does a 1988 350 v-8 Chevy 4-wheel driv engine blow oil filters?
The most common cause of that is that there is an old O-RING stuck to the engine block where the oil filter goes. Take the filter off and make sure there is no gasket / O-ring stuck to the block. If you don't find your problem there, Then let us know and we'll try to help you.
Where is thermostat located on a 1999 Chevy Silverado?
follow your top radiator hose to the engine block. the hose will be attached to the thermostat housing. the housing is attached to the block with two bolts. remove the radiator hose from the housing, remove the two bolts, and gently separate the housing from the block. you will see the thermostat. The above answer is for a V6 engine. If your engine is a V8, follow the lower radiator hose toward the engine. The thermostat, housing & o-ring are one piece.
How do you assemble the Estes model rocket launch stand?
They all come with very detailed instructions, follow them carefully. Most important is gluing the fins absolutely parallel to the body. Also use a light glue like crazy glue, rather than white glue.
Your 89 350 tbi is blowing the oring out of the filter what could be wrong?
You need to make sure that there is not a o-ring stuck on the engine block from the old filter. sometimes the old gasket will stick to the engine block when you change the oil filter and it will leak everytime. If you don't find the problem there, then you will need to ask your question again.
