i) leakage flux is those flux which goes through the air and linkage flux is those flux whose go through the cell. ii)leakage flux is the loss at flux but linkage flu is warning flux. iii)leakage flux is cause of eddy current loss and linkage flux is case of copper loss.
light speeeed mofos
Basically useful fluke is the flux that flows with in the magnetic circuit of an armature. That is why when there is an air gap the flux enters the armature which makes it useful flux! Hope that answers your question!
A generator, in general.
Flux linkage is determined by magnets. The constant flux (Wb) per pole pairs induced in the stator windings of the magnets. Flux established by the permanent magnets produce three trapezoidal back EMP waveforms.
i) leakage flux is those flux which goes through the air and linkage flux is those flux whose go through the cell. ii)leakage flux is the loss at flux but linkage flu is warning flux. iii)leakage flux is cause of eddy current loss and linkage flux is case of copper loss.
Billy Glaze was born in 1944.
Peter Glaze is 5' 5".
racipe of the glaze for sanitary ware
The Ratio of the total flux ( flux in iron path) to the useful flux (flux in air gap)
Confectioner's Glaze, which is also known as resinous glaze, pure food glaze, natural glaze, and pharmacutical glaze, is an alcohol-based solution. When it is created, dried flakes of shellac (which is made from the secretions of female lac bugs) are re-dissolved in denatured alcohol.
when a current flow through the coil then flux produced around the coil . if the flux linked same produced coil only then the flux is said to be leakage flux. flux produced by one coil ,but linked with another coil then the flu is said to be mutual flux.
when a current flow through the coil then flux produced around the coil . if the flux linked same produced coil only then the flux is said to be leakage flux. flux produced by one coil ,but linked with another coil then the flu is said to be mutual flux.
The duration of Honey Glaze is 1.42 hours.
Haley ray invented glaze on febuary 8,1888.
First you would paint the vase with a glaze. Then you must put it in a kiln for a specified amount of time in order to set the glaze.
In a Transformer, Core flux is the difference of primary flux and Secondary flux which are opposite to each other in direction. There difference is equal to the no load flux at all loads. So, some of primary flux passes through the core and remaining becomes leakage flux (Because Secondary flux forces it to get out of the core). Same is the case with Secondary flux. Now, flux is directly proportional to Voltage and Current. When Current increases due to increased load (and voltage remains same): Then both primary and secondary flux increase. Because both of them increase, so there difference remains same. And all remaining flux is forced out. Hence leakage flux increases with current, but Core flux remains constant. When Primary Voltage is increased: Then only primary flux increases. So difference of this new increased primary flux and previous same secondary flux increases. Hence Core flux increases with voltage, But leakage flux does not. That's how In transformer core flux depends on voltage whereas leakage flux depends on current.