0
What else can I help you with?
I need to disconnect the transmission line from the bottom of my radaitor on my Dakota PU. I have a sissor like disconnect tool but can't seem to figure out how to use it?
the line is a quick disconnect to operate your tool is to simply open it up place it on the line with the stems facing the connector and push in on the tool once the tool is fully seated keep pressure on the tool while pulling on the line to remove it. good luck
How do you disconnect fuel line on 2001 Dodge Dakota?
You need a special tool called a fuel line disconnect to release the tabs.
How do you disconnect fule line on 2000 Chevy s10 pickup without proper tool?
You can purchase a tool for that job for probably under $10 from your local auto parts store. If you attempt to disconnect the line without the proper tool you will damage it.
How do you remove quick disconnect transmission line on a jeep?
Easy use a quick disconnect tool or a small screwdriver
On a 1997 crown Victoria how do you disconnect the fuel lines that attach to the pump?
ford fuel line disconnect tool. available at your local auto parts store.
How do you disconnect the quick disconnect fuel line on a 1998 grand voyager?
buy a fuel Quick disconnect tool. They make cheap plastic ones, and slightly more expensive metal ones
How do you use a fuel line disconnect tool for a ford explorer?
open the tool, slide it over the line and into the groove between the two sides. push and twist it to release inside tabs. pull apart
Ford tool number T88T-70522-A?
thetool is used to disconnect the hydraulic clutch line from the slave cylinder
How do you disconnect the fuel filter on a Saturn LW model?
Purchase a fuel line disconnect tool from the parts store, there are several types so get the right one. The fittings are spring loaded and need to be pushed in with the tool then pulled apart.
1999 suburban fuel pump replacement Do the fuel lines disconnect at the tank or at the filler line part Is there a special tool needed?
The fuel lines disconnect at the tank and yes there is a tool required. You can get it at advanced or discount auto for a couple of bucks.
What special tool do you use to disconnect quick connector on slave cylinder on 1990 for ranger?
To disconnect the quick connector on the slave cylinder of a 1990 Ford Ranger, you typically need a specialized quick disconnect tool, often referred to as a fuel line disconnect tool or a quick disconnect tool. This tool has a design that allows it to slide over the connector and release the clips holding it in place without damaging the fittings. Make sure to select the right size for the specific connector on your vehicle. Always consult your service manual for any specific instructions related to your model.
How do you disconnect fuel line from motor on a 1995 Dodge Ram?
Your local auto parts store can sell or rent you an inexpensive tool that disconnects the fuel line.
