It is a low profile, approx. 2" elliptical shaped device that screws to the top frame of a gazebo canopy at prescribed intervals. The matching canopy grommet is placed over it and the small knob on top of the lock is rotated 90 degrees to lock the canopy in place
what is a screw
Just exactly the same way you screw into wood.
there is no translation for screw you
The mechanical advantage of a screw can be found by dividing the circumference of the screw by the pitch of the screw. In this case, the total mechanical advantage is equal to the circumference of the simple machine to which the effort force is applied divided by the pitch of the screw.
a screw, a bolt, or a nut.
You have to open the trunk lid, under the lock on the inside you will find a screw, remove the screw and the lock retaining clip, pull the lock out. If you can not open the trunk lid, drill the lock center out, and you should be able to open with a screw driver.
screw
The screw is to change between a luminous flame(orange) and non-luminous flame(blue). You should always screw the lock so that it covers the hole first.
the VLIF socket is used to make use of the set screw to lock the CPU into place.
Just pull the screw on the side of it.
look at the column around the ignition lock their is a set screw you must loosen and lock along with barrel will slide rite out.
Don't understand what is meant by "light bulb lock."
there is a screw clearly in back of the door handle along with a screw behind the door lock, you must remove the plastic lock switch and find the screw there. also a screw under the panel holding the door tray, but optional. then slide the door panel out upwards
no
because when the grand wizard locks you out you are screwed.
You turn a mortise cylinder lock slightly before removing to release it from the lock housing. There is an obstruction in the lock design to keep the cylinder more secure in the lock. After you remove the holding screw from the lock body you can turn the cylinder slightly to release it and remove from the lock housing. Not all mortise cylinders are designed this way. Some of the cylinders unscrew from the lock housing after releasing the cylinder retaining screw.
With the lock mechanism missing, look into the hole where the lock should be. Take a flat screw driver and insert it into the slot near the back of the lock hole and twist.