answersLogoWhite

0

What is a posicle?

User Avatar

Anonymous

12y ago
Updated: 8/17/2019

a popsicle is a cold soothing desert. It has many flavours. Is it made up of 90% water, sugar, corn syrup, gum and stabalizers.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How would you lick a posicle?

Tell P-lo to


Which melts faster a water popsicle or a milk posicle?

Water Popsicle. Less dense!


Is pizza a pickle?

Um... Not really. But eating it by itself is okay.


How do you test a popsicle stick bridge?

You want to find out how much weight your posicle bridge can hold before collpsing. So finding the weight of the bags of weights is very important to test your bridge. Then you will find out how much weight your posicle bridge can hold. ~be happy, life is good:)~


What is a lolipop is it a posicle?

A lollipop is a hard candy attached to the end of a stick, usually portrayed as being a flat, circle of swirling candy. A popsicle is frozen sweet juice on a stick. A lollipop is not a popsicle, though popsicles are sometimes referred to as 'ice lollies.'


How do you make toy horse stalls?

You can buy popsicle sticks aproximitly 300+ and 300+ hot glue sitcks and a hot glue gun then look up how to make a breyer barn out of posicle sticks by mybreyerbarn100 on youtube then just follow and watch


If the needle on the speedo of a 79 Z28 breaks off can you replace it or do you need a new odometer?

To do that kind of repair you'll need to remove the speed/mile odometer from the instrument cluster anyway. Most people would say that the cost of a replacement speed/mile odometer is justified and the fastest way to make the repair. This would involve switching over the number stack to keep the elapsed miles of your car intact. You can repair the needle if the center of the needle is undamaged with some fast drying epoxy. The repaired appearance depends on being very careful when you mend the break in the needle not to grunge up the faceplate or the needle itself or destroy the spedometer by changing the weight on the needle. Thoroughly wash your hands and avoid touching the metal face plate itself. Any finger oils will become blotches over time so it's best to work with a large tweezer rather than handle anything that touches or gets near the number face If you have the part that broke off and as if center pivot shaft is unbent the first step would be to use a razor blade to remove a tiny shred of material off the tip of the old needle. And I do mean a very small nearly unnoticable amount. Lay a spacer made from an inch and a half of wood popsicle stick to build up the area on the face even with where the needle normally lays. You must top off whatever you use with a small strip of wax paper. You will use this as an alignment assist to align the two halves of the broken needle. Next, mix a very small amount of quick setting epoxy which will be used to weld it back together. Then use a toothpick to pick up just enough of the epoxy to coat both ends of the broken needle and making sure you only coat the broken ends. Then align the needle halves together on the face and wait for them to dry, after which you can slide the posicle stick and wax paper away and the needle should hold just fine and be the within the proper weight range.