0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you take out your nose ring?
Well if it's a captive bead ring (a ring with a bead on it) just push the bead out of the opening of the ring and roll the ring out of the piercing.
How do you get out a belly ring that is round?
Push the bead out sideways from the ring, roll the ring around and out of the piercing. If you can't get the bead out see your piercer and have them open it with ring expanding pliers.
How do you take off a captive bead ring?
Push the bead sideways till it pops out and roll the ring out of the piercing.
How do you remove the horn ring on a 1966 Plymouth satellite?
Push in the horn ring in slightly on both sides and turn just the chrome horn ring counterclockwise. This is for the 2 spoke ring only.
How do you pull out a weopen from under the ring on smackdown vs raw ps2?
you go outside of the ring face the ring push x you will have a weapon this works for ps2/ps3
How do you look under the ring on xbox on Smackdown vs Raw 2009?
you push a
What do i do if my nose ring wont go through the last layer?
Push it though....
How do you get your belly button ring pirece out?
It's called a "captive bead ring", push the bead out of the ring sideways once the bead is out you can then remove the ring, to replace it just reverse the procedure and snap the bead back in.
How do you clean Hydraulic Lash Adjusters?
Push the plunger down and pull the snap ring.
Can your rat ring a bell when she is hungry?
Yes. Rats are quite intelligent and can be trained to push a button or push a small bell around to signal that they are hungry.
Where does the o-ring go that came with the kit to replace a water pump in a 1990 KF Laser?
There is a pipe that goes into the pump. Put the 'O' ring on the pipe and push in
What holds the mounting ring to the backup flange berides the 3 screws?
If you are talking about a garbage disposal, there is a snap ring around the base of the tube coming down. Loosen the three screws, push up on the flange the screws go through and you will see the snap ring. It is what the flange rests on so that the screws can push up against the bottom of the sink.
