A sub-woofer is a loudspeaker that produces extreme low tones that other speakers cannot
It means that the loudspeaker maker tells you that his loudspeaker builds an input impedance (load impedance) of Zload = 4 to 8 ohms. In audio we use always voltage matching and so the amplifier output should have a source impedance of smaller Zsource = 0.1 ohm. Scroll down to related links and look for "Damping Factor".
Output of the power amplifier is smaller 0.1 ohms and input of the loudspeaker is more than 4 ohms.
Scroll down to related links and look at "Interconnection of two units" and find the impedance picture of amplifier and loudspeaker or microphone and amplifier. Learn about "voltage bridging" - Zout < Zin.
Yes, but the sensitivity and frequency response will be very poor. The diaphragm on a microphone, corresponding to the voice coil and cone on a speaker, is extraordinarily light and compliant.
If the modulation index is greater than 1 (more than 100% modulation) the modulated carrier signal is periodically reduced to zero. This does not effect the transmitter but at the receiver these "dead carrier" intervals result in dropouts in the audio stream from the loudspeaker producing a distorted output that is difficult to understand.
lg ks360 does have a loudspeaker !
up your neighbour's loudspeaker?
The duration of The Loudspeaker is 1.12 hours.
No, Loudspeaker is an output device.
The Loudspeaker was created on 1934-06-01.
Name: Johann Phillip Reis-1st loudspeaker Name: Alexander Graham Bell - Electric loudspeaker
1) Crystal Loudspeaker 2) Electrostatic (Condenser/Capacitor) Loudspeaker 3) Dynamic Loudspeaker
The duration of Loudspeaker - film - is 2.02 hours.
Loudspeaker - film - was created on 2009-09-20.
Loudspeaker Design Cookbook was created in 2006.
In p.e my coach uses a loudspeaker to talk to us
A loudspeaker is a transducer that converts electrical energy to sound energy.