Use a taper or have a shop taper it out.
The purpose of measuring taper angle is to obtain taper angle
To measure bore taper
Seat the bolts using the 4 lb. hammer and taper bolt gauge
You should use a taper. You can probably find these at a piercing studio. It is important to first stretch it to a 16 gauge, and then to a 14 gauge about a month later to prevent tearing.
3/8
I would just go back to the shop you had it pierced at and have them run a taper through it. It's usually free and it's much easier than trying to mess with that kind of stuff yourself. But definitely use a taper. You don't want to just stuff the bigger one through...
Yes but you need to have this done by a professional body piercer who will use and insertion taper to put the new jewellery in the piercing. 14 gauge is thicker than 16 gauge and should be stretched up by use of a taper, forcing the jewellery into the hole will tear the piercing.
taper it and let it heal over a bit of time....i'd say a week or so, i lube up with neosporin before i put the taper in personally, it helps quicken the healing process
Tapers come in all different sizes. From 14g to 1 inch, But I don't suggest using tapers after 0g.
You shouldn't need to leave the taper in at all, a lot of tapers have a notch in the back that jewelry fits into, so when you slide the taper through your body, the jewelry can slide through the hole behind it. So just use lubrication and slide it through with a consistent amount of pressure in one swift motion.
This is the formula for calculating a taper: Large diameter of the taper minus the small Diameter of the taper divided by the length of of the taper will give you the taper per inch. You will also need to know the included angle of the taper if you ar cutting this taper. This formula would be Tangent of the included angle divide by 2.