it is the block which is used to splitting the two circuit
In the service distribution panel there are termination points at the top of the panel. Two of the utilities "hot" conductors terminate on the main breaker. The neutral utility termination point is on a terminal block usually off to the side near the main hot terminations. It is in this neutral termination block where the system ground connects from the ground rods to the distribution panel. For a 100 amp panel the wire size will be a #6 bare copper conductor.
Termination
1) Project Termination by Extinction 2) Project Termination by Addition 3) Project Termination by Integration 4) Project Termination by Starvation
RJ-11 modular jack, RJ-11 modular jack on the wall, protector block on the outside of the house, to the lugs in the protector box were it terminates, the termination forms a bridge between the house and the outside plant telephone wire. A drop wire connects the block to the nearest telephone pole termination point. The main distribution frame at the central office which has a vertical side and a horizontal side. The termination from the outside plant is on the vertical side and the switch is connected to the horizontal side.
In active termination scheme it removes the thermal noise which results in the passive termination due to the end resistors..
How can u define "Termination of Contract"?
termination without just cause
termination
Swirly Termination was created in 2000.
Fatal Termination was created in 1990.
Yes, Termination of Approving Official accounts results in the termination of all cardholder accounts assigned to them.
In a notification letter about termination you should consider including the following: Reasons for termination; Terms of termination; Whether good recommendations will be given; Sincere apologies.