a throttle sensor sends a message to the computer. it tells the computer how much peadl u have given it . this way the computer knows how much gas, what fuel/air mix and what gear to give
The Pontiac Grand Prix was produced from the years 1962 to 2008. The throttle position sensor in a 3.8 V6 Pontiac Grand Prix is located on the butterfly spindle of the throttle body.
since the throttle is electronic i would assume its on your gas pedal
replacing a fuel sensor on a 2003 grand prix?
It is on the accelerator pedal. You have to replace the whole pedal assembly
How do you replace a water pump on 2001 Grand prix?" How do you replace a water pump on 2001 Grand prix?"
This sensor is located on the air intake track. This sensor will only have two wires coming from itÊandÊthis sensor is also called the throttle body.
its the flat square one on top of the throttle body
I don't know the exact location for your vehicle, but it's usually in the air filter housing or the duct work from there to the throttle body.
How to change an air filter in a 2001 Grand Prix.
you buy one that fits that make and model holly makes one i have one on my 2001 grand prix.
Malta Grand Prix ended in 2001.
Grand Prix of Texas ended in 2001.
It's located in the throttle bosy itseld, on the opposite side of the gas cable. it's a circular flat piece of plastic with a cable connected to it, you probabbly need to remove the intake tube in order to see it.
Usually the Throttle Position Sensor is located by the intake manifold, usually at the end of your air intake.
It is right below the thermostat housing on the drivers side of the engine, below the throttle body.
location knock sensor 2002 pontiac grand prix gt 3.8 engine
where to locate heater fuses for a 2001 grand prix gt
San Francisco Grand Prix was created in 2001.
The 1996 Pontiac Grand Prix cooling fan sensor is located on the front of the engine. The fan sensor can be found just above the thermostat.
Butterfly in the throttle body needs cleaning.
it is attached to the throttle body the left side of it should have i think 3 wires coming out of it
It is most likely your wheel bearing, there is a speed sensor in side of it.
Low coolant or a defective sensor
Trouble code C1287 means: Steering Sensor Rate Malfunction