a tire or tube in a tire. could be an engine valve you`d probably have to be more spacific
The valve face
The part of a car that uses a Schrader valve is the tire. The Schrader valve is commonly just called a tire valve. The valve consists of a stem, core and cap.
The spline that lifts and lowers the part to shut the valve be globe or gate valve
It's the part that actually pushes a valve to open it.
It is part of the EGR valve on the back of the engine.It is part of the EGR valve on the back of the engine.
It may be the Positive Crankcase Ventilation (PCV) valve. This valve is usually installed into the valve cover and has a hose connected to it.
The part where you hold on to the horn is the valve casing. The valves are inside of that.
tricuspid valve and mitral valve
It is best to replace it. The failure happens in the electrical part of the valve, not the pintle and seat.It is best to replace it. The failure happens in the electrical part of the valve, not the pintle and seat.
Normally inside the tire, on the rim. May be part of the valve stem.
The pipe - the valve stem - is narrower at the top. And the valve spindle sits with a thicker part below the narrower part of the stem. When you turn the little nut on top of the spindle you pull the thicker part of the spindle into the narrower part of the stem to create a seal and to close the valve. To open you unscrew the nut and push the spindle down.
The Valve is the piece that actually moves in and out, or "opens and closes" - the part of the block that the valve rests on is called the valve seat.