No. A voltage regulator usually can provide control in both directions (increasing or decreasing voltages). A voltage limiter clamps the voltage to below a specific level.
Voltage Regulator? In the alternator voltage limiter? voltage regulator...a little square box usually located on the driver side wheel well.
No. A zener diode is a voltage limiter. Circuit design might create a current limiting response, but the basic control is voltage, not current.
It reduces the voltage from 12v to 6v because the gauges run on the lower voltage.
bcoz, voltage clipping limits the voltage to a device without affecting the rest of the waveform.
there is a porcelain block on the firewall called a ballast resistor that limits voltage to the starter and there is also the voltage regulator that regulates voltage to the battery.
0.7 V
Sometimes called a snubber. It often consists of a zener diode wired so that some voltage or other cannot exceed the zener voltage. Others use transistors or FETs in more active topologies. The ultimate is a crowbar limiter which simply shorts out a power supply if it exceeds a certain voltage, thus rupturing the supply fuse. (I sometimes refer to them as Sayonara circuits.)
In an electronic circuit power supply voltage is generally fixed. Resistors is a current limiter for correct devices polarization.
A positive limiter differs from a negatives limiter when it comes to places of input for guard of instrument. They also differ in audio circuits.
i believe it has a limiter..
The polarity at which it limits a waveform.