don't worry
CL of a CT is its accuracy class.. it is an approximate measure of the CT's accuracy. e.g. The ratio (primary to secondary current) error of a Class 1 (CL:1.0) CT is 1% at rated current
RCT is Secondary resistance of Current transformer it depends on Design.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.
CL of a CT is its accuracy class.. it is an approximate measure of the CT's accuracy. e.g. The ratio (primary to secondary current) error of a Class 1 (CL:1.0) CT is 1% at rated current
CL of a CT is its accuracy class.. it is an approximate measure of the CT's accuracy. e.g. The ratio (primary to secondary current) error of a Class 1 (CL:1.0) CT is 1% at rated current
RCT is Secondary resistance of Current transformer it depends on Design.
Technically YES, but state authorities do not approve the method. The purpose of both application is different and hence the design of class of accuracy, rating etc would be different for both application.
if mark specification of CT mention 5P20 + 0.2,am used at site seconder metering with class 0.2.my question is, at secunder CT site must used auxiliary CT with class 0.2, or not used.tank your answer.
Leakage reactance is useful for limiting the short circuit current in transformer and generators. therefore normally the reactance of transformer varies for 4.5% for distribution transformer to 12.5% for 400KV class.
These are the Class codes for CTs used for protection purposes.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
Class X CTs are special CTs used mainly in balanced protection systems (including restricted earth fault) where the system is sensitively dependent on CT accuracy. Further to the general CT specifications, the manufacturer needs to know: • Vkp - Voltage knee point • Io - Maximum magnetising current at Vkp • Rs - Maximum resistance of the secondary winding
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.
It is a transformer with No load attach to it.