It is a device used to protect Electric Network and loads
The single phase induction motors are made self starting by providing an additional flux by some additional means. Now depending upon these additional means the single phase induction motors are classified as: 1.Split phase induction motor. 2.Capacitor start inductor motor. 3.Capacitor start capacitor run induction motor. 4. Shaded pole induction motor.
The rotor will jam.
Advantages, Disadvantages and ApplicationsThe various advantages of Shaded pole motors includes Very cheap and reliableEasy to constructExtremely rugged in natureDisadvantages includesLow efficiencyLow starting torqueSince the shading coil is made of copper, the copper loss is high.See the related link for further information.
because its possible only where pole changing arrangements are given and pole changed motor draws more current then its actual pole which damages its windings.
Yes, the rotation of a shaded pole motor can be reversed. It is advisable to only attempt this on a small motor and if you have general mechanical and electrical knowledge. The simple and direct explanation is one has to flip the stator. To do this the motor must be disassembled to a point at which the rotor can be removed. Once removed, turn it end over end and reinstall. Done. Note that the bearing housing ends will likely have to be switched as well.
When the coil in the relay needs to run off an AC signal rather than DC. The shaded pole keeps the relay from "chattering" every time the AC current crosses 0v on the sine wave.
The single phase induction motors are made self starting by providing an additional flux by some additional means. Now depending upon these additional means the single phase induction motors are classified as: 1.Split phase induction motor. 2.Capacitor start inductor motor. 3.Capacitor start capacitor run induction motor. 4. Shaded pole induction motor.
2
shaded pole
Most likely the motor will be a shaded pole induction motor. If the food mixer has a place for brushed on the side of the motor and are oppositely opposed to each other, then it would be a universal motor.
The rotor is made up of laminated steel discs that are pressed on to a common shaft. This shaft has bearings mounted on either end which allows the rotor to spin within the frame of the motor. The shorting bars on the rotor are usually made of aluminium.
15 to 40 ohms.
The frequency of the applied voltage is consant.
The frequency of the applied voltage is constant.
what is the meaning of ac relay and dc relay EDIT: a DC relay is simply a coil and core that pulls on an armature. An AC relay usually needs a shaded-pole core (couple of copper loops) to prevent the armature from vibrating at 60 cycles or so. The core, also, is laminated steel like a transformer; so is the armature to help contain the magnetic field. You should not substitute a DC rated relay for an AC , but the reverse should be ok, if voltage and current ratings are the same.
The rotor will jam.
The motor used in a table fan is usually a shaded pole motor.