The advantage of an elecromagnet is that you can turn it on and off with a simple switch.
So for example if you want to pick up a scrap car with a crane/electromagnet and move it, you can turn the electromagnet off when you want to release the car.
You could not do the with a permanent magnet obviously.
convert electrical energy to energy of motion...! the usage of an electromagnet allows us to control the flow of electrons to the electric rotor,thereby allowing us to control the working of the rotor,whereas with a permanent magnet there will be a continuous supply of energy which can be stopped only if the magnet is damaged or heated.
A regular magnet, "Earth Magnet", can be very strong, the disadvantage of using them is that you cannot turn off the magnet. Electromagnet uses the electricity of a common battery and can be turned on and off, such as for switches in a circuit board.
No an electromagNet is created via electricity, once the electricity stops so does the magnet it can be created using a current in a wire tightly wrapped around a iron or metal rod
Can be turned off
An electro-magnet can be switched on & off - a bar magnet is 'permanent' Think of a scrap-yard. If the magnet they use to pick up huge quantities of metal were permanent, they'd have to manually remove every piece. With an electro-magnet, they simply turn the power on to pick up a load, and off when they want to release it. You can make your own electro-magnet with a battery, some wire and a large nail.
convert electrical energy to energy of motion...! the usage of an electromagnet allows us to control the flow of electrons to the electric rotor,thereby allowing us to control the working of the rotor,whereas with a permanent magnet there will be a continuous supply of energy which can be stopped only if the magnet is damaged or heated.
A regular magnet, "Earth Magnet", can be very strong, the disadvantage of using them is that you cannot turn off the magnet. Electromagnet uses the electricity of a common battery and can be turned on and off, such as for switches in a circuit board.
No an electromagNet is created via electricity, once the electricity stops so does the magnet it can be created using a current in a wire tightly wrapped around a iron or metal rod
That is an electromagnet.
Can be turned off
An electro-magnet can be switched on & off - a bar magnet is 'permanent' Think of a scrap-yard. If the magnet they use to pick up huge quantities of metal were permanent, they'd have to manually remove every piece. With an electro-magnet, they simply turn the power on to pick up a load, and off when they want to release it. You can make your own electro-magnet with a battery, some wire and a large nail.
An electromagnet. Unlike other magnets it can be switched on and off.
Put the South pole of the nail against the bar magnet to see if it attracts or repels.
The difference between an electromagnet and a bar magnet is that the bar (steel) magnet is always turned on, therefore always magnetic. The electromagnet is a magnet that is powerd by a battery so you can turn it on and off.
using a magnet: steel atracts and aluminum doesn't
Of course, using a magnet (electromagnet). This is valid for many mixtures.
Of course . You can make such a magnet easily using a safety pin. Take a safety pin and magnetize it using a permanent magnet. Then unfold it. The ends will have same poles and at the middle you will have the other. So you can have a magnet with three poles. Verify it using compass.