answersLogoWhite

0

The bearing lets the belt pully free wheel on the compressor input shaft that the clutch is attached to.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you check air conditioning clutch coil?

how do you oheck air conditioning clutch coil to see if it is overlouding alternator


Air conditioning clutch on a 94 ford aerostar van?

What exactly do you want to know about "Air conditioning clutch on a 94 ford aerostar van?" How to replace? What engine do you have, etc.?


Where is the AC clutch relay located on a 1995 Cadillac eldorado?

The 1995 Cadillac Eldorado air conditioning clutch relay switch can be found on the firewall in the engine compartment. The air conditioning clutch relay switch will be on the passenger side of the firewall.


Where is the AC clutch relay switch located on a 2003 F350?

The 2003 Ford F3 50 air conditioning clutch relay switch can be found on the firewall in the engine compartment. The air conditioning clutch relay switch will be on the passenger side of the firewall.


How do you take a air conditioning clutch off a 1997 thunderbird?

use a chainsaw


How do you replace the clutch and bearing on a ac compressor for a 2002 Chevrolet blazer?

This requires special tools to remove and install the ac clutch and bearing. The air gap on the ac clutch must be done during install.


Where is the fuse for jeep Cherokee air conditioner clutch?

There is no fuses for the air conditioning clutch, but there is a relay mounted on the passenger fender beside the fuel pump relay.


Can you replace clutch bearing in the air conditioner of a 82 dodge ramcharger?

yes you can


What makes Chevy blazer air compressor squeal?

bad clutch bearing


Where is Air conditioning compressor clutch relay on 2001 Bravada?

Its in the fuse block - underhood.......


What is trouble code 33 on 1995 jeep wrangler?

Air conditioning clutch relay.


How AC compressor clutch bearing?

The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.