0
Memory modules that utilize temporary storage areas (known as buffers) to help manage the data sent to the memory by the memory controller. Buffers act as current regulators keeping the amount of current flowing to and from the chips at optimal levels. The purpose of this is to allow for more memory chips on modules by keeping the memory from being overloaded by the chipset. It can also be used to allow more modules to be used in the system. Not all systems can use buffered memory; the type of memory required is dependent upon the computer's memory controller.
Buffered memory is an older term for registered memory.
However, some new large systems use "fully buffered memory". In normal registered/buffered memory only the control lines are buffered, in fully buffered memory the data lines are buffered as well.
Wiki User
∙ 15y ago
Wiki User
∙ 10y agoBuffer memory refers to the temporary storage area for the generated or acquired data.
Add your answer:
Earn +20 pts
Mixing unbuffered memory with buffered or registered memory will work but is not recommended?
FALSE
Will mixing unbuffered memory with buffered memory work?
the simple answer is no and ECC will not work on alot of MOBO's
What are the different types of buffering in unix?
Fuly buffered Line buffered Un buffered
WHAT IS THE ABBREVIATION FOR Neutral Buffered Formalin?
abbreviation for Neutral Buffered Formalin
Is it necessary to use Buffered Reader to read in java?
Buffered Reader increases efficiency of I/O.
What does unbuffered mean in terms of ram?
buffered ram is ram that buffers data before it fully excepts it. its like the same as ecc error correcting code. buffered is better than unbuffered as long as your mother board takes it. you have to check your ram you have now and see if it has it. but be careful of static, it can killl your memory chips and boards.
What is the difference between aspirin to buffered aspirin?
Buffered aspirin has an added buffering agent so that it is easier on the stomach.
Can you subsitute unbuffered SDRAM module?
Ive just been studying about all the forms of SDRAM etc, and when it came to buffered/registered DRAM I found out that normal PC's usually have upto 4 slots for SDRAM, any more gives producers of motherboards lots of electrical problems. So to solve the problem of systems that require maybe 6, 8 slots, they require special DRAM, such as buffered/registered SDRAM. This SDRAM has a special buffering chip on the address bus added to it to work as an intermediary between SDRAM & North Bridge. To take advantage of buffered SDRAM, the motherboard and brige must be able to support SDRAM. Slots requiring buffered DIMMs are keyed differently then those requiring unbuffered DIMMS so it will be physically not possible to install these DIMMs into the slots short of shaving the key. Electrically, possibly, but you have to remember that the register drives the addressing unit on the DIMM and the bridge will likely not be designed to accomidate the drain required to directly drive the memory chips on the address bus and as such may cause instability if it works at all. In addition there is a single clockcycle delay from when the address is written to the registers to when the address is propigated to the memory, in such timing errors could arrise from a bridge expecting that delay. - you cannot use unbuffered SDRAM on a motherboard that supports buffered memory, because the notches on buffered DIMMS are in different positions than for unbuffered DIMMS.
What is a buffered solution?
It resists changes in pH.
Are new and delete operators in c plus plus related to flush?
The new and delete operators in C++ are not related to flush. New is used to allocate memory, while delete is used to deallocate memory. Flush is a library concept that allows you to ensure that IO is completed, and not buffered, before proceeding to the next step.
Liquids that resist large changes in pH are?
buffered
What is 1x PBS?
It is just Phosphate buffered saline.
