M30 - Coarse 3.5mm, Fine 2.0mm?Metric Thread Pitch and Tapping SizesSizePitch (mm)Tapping Diameter (mm)Clearance Holes (mm)CoarseFineCoarseFineCloseMediumCoarseM1.60.351.251.71.82.0M20.41.62.22.42.6M2.50.452.052.72.93.1M30.52.53.23.43.6M40.73.34.34.54.8M50.84.25.35.55.8M61.05.06.46.67.0M81.251.06.87.08.49.010.0M101.51.258.58.710.511.012.0M121.751.2510.210.8131415M162.01.514.014.517.018.019.0M202.51.517.518.521.022.024.0M243.02.021.022.025.026.028.0M303.52.026.528.031.033.035.0M364.03.032.033.037.039.042.0
I am looking for some sandpaper that is more coarse than this. My beard is no more than a coarse stubble, right now.
A peridotite is a dense, coarse-grained igneous rock
Example sentence - We prefer the coarse ground pepper over the fine ground pepper.
Granite is a coarse grained igneous rock without Pyroxene.
unc is coarse, unf is fine pitch
A fine pitch setting on a propeller takes a smaller bite of air, or water, allowing more engine rpm (power) at lower speeds. A coarser pitch (higher number pitch angle) takes a larger bite of the medium, and when properly matched to the engine potential, produces a higher speed. The difference between the fine and coarse setting may only be a few degrees.
That is a coarse piece of sandpaper! His coarse behavior will not be tolerated.
Depends on the pitch: Fine pitch: m10 * 0.75 pitch , drill diameter = 9.25 mm m10 * 1.0 pitch , drill diameter = 9.00 mm m10 * 1.25pitch , drill diameter = 8.8 mm Coarse pitch (most common use): m10 * 1.5 pitch , drill diameter = 8.5 mm
Wheel bearing won't have any threads. If your talking about the post they mount on, then you can use a pitch gage to get the number of threads per inch and then compare that to a thread chart to determine if they are coarse or fine.
coarse soil
It is coarse-grained.
coarse course
All thread pitches are standard inch size thread pitches. I can't be more specific than that since I don't know exactly which bolt you are talking about. An example for you is the starter bolts are a 3/8-16 pitch, which is standard coarse thread. Most body panel bolts are either 5/16-18 or 3/8-16 pitch, once again, standard coarse thread pitches.
The homophone of "course" is "coarse." "Course" refers to a path or direction, while "coarse" means rough or not fine in texture.
not coarse at all
A homophone for "coarse" is "course." They sound the same but have different meanings.