answersLogoWhite

0

Trouble code P0356 means:Ignition coil F primary/secondary circuit malfunction

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What does the 2004 ford f150 error code p2111 mean?

Trouble code P2111 means: Throttle Actuator Control System - Stuck Open


What is the rear axle code on a 2004 ford f150?

Open the drivers door and look for an information sticker on the end of the door It will have the axle code for your truck


Axle ratio code on 2004 f150 is 27?

No, I have a 3.55 in mine, I think there is one lower than that, and then a 3.73, and then a 4.10. What the hell is a 27? ---------------------------------------------------------------------- " OILMAN " had submitted a list of axle codes for the 1997 - 2004 F150 / F250 and the list shows axle code 27 as being a 3.31 conventional differential


What does obd code 2195 mean on a 2004 ford f150?

Trouble code P2195 means: Lack of HO2S-11 Switching, Sensor Indicates Lean


What does the 2004 ford F150 error code P2106 mean?

Trouble code P2106 means: Throttle actuator control (TAC) system-forced limited power mode


Where is iac valve on 2004 ford f150 4.6 v8?

no have , per wiring diagram.There is no IAC motor for this engine and I suspect you have an error code


How do i deactivate the 2004 ford f150 truck alarm?

i lost the ignition key anl keyless remote on my for f150 2004 truck


On a 2007 F-150 what does axle code 26 mean?

I'm not sure if this is the same on a 2007 , but axle code 26 for 1997 to 2004 F150 trucks is a 3.73 conventional axle


How to remove factory radio from 2004 ford f150?

How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck


What is a C1342 code?

how to fix a c1342 code on a ford f150


Your 2004 Ford F150 4.6 liter truck is giving a P0506 code how to fix?

Trouble code P0506 means: Idle Air Control System RPM Lower Than Expected


What does the 2004 Ford F-150 error code P2195 mean?

The error code P2195 on a 2004 Ford F150 indicates that there is a fault between electronic throttle system and TP1 and TP2 reference points. This can be caused by pinched wires or a glitch in the TPS system.