Trouble code P2111 means: Throttle Actuator Control System - Stuck Open
no have , per wiring diagram.There is no IAC motor for this engine and I suspect you have an error code
The error code P2195 on a 2004 Ford F150 indicates that there is a fault between electronic throttle system and TP1 and TP2 reference points. This can be caused by pinched wires or a glitch in the TPS system.
Trouble code P2106 means: Throttle actuator control (TAC) system-forced limited power mode
misfire # 1 cylinder
Idle Air Control Overspeed Error
Trouble code P0356 means:Ignition coil F primary/secondary circuit malfunction
Trouble code P0506 means: Idle control system, rpm lower then expected
EVAP Purge Solenoid Stuck Open or Closed
The PO135 error code on a Ford F150 indicates a problem with the oxygen sensor circuit for the bank 1 sensor 1. To fix this issue, first, check the wiring and connectors for any damage or corrosion. If they are in good condition, replace the oxygen sensor itself. After replacing the sensor, clear the error code and take the vehicle for a test drive to ensure the issue is resolved.
Open the drivers door and look for an information sticker on the end of the door It will have the axle code for your truck
No, I have a 3.55 in mine, I think there is one lower than that, and then a 3.73, and then a 4.10. What the hell is a 27? ---------------------------------------------------------------------- " OILMAN " had submitted a list of axle codes for the 1997 - 2004 F150 / F250 and the list shows axle code 27 as being a 3.31 conventional differential
I don't believe you can do that with OBD2 systems.