Ohm's Law: Current is voltage divided by resistance.
Alternative AnswerIf, by 'statement', you are referring to a 'law', then there is no electrical law that states that 'current is voltage divided by resistance'.
The relationship between voltage, current, and resistance is derived from the definition of the ohm, which is defined in terms of a volt per ampere, which can be manipulated to say that 'current is equal to voltage divided by resistance'.
This is frequently, but incorrectly, described as being 'Ohm's Law', but Ohm's Law isn't universal and it only applies to a very limited range of linear (or 'ohmic') loads, whereas 'resistance is voltage divided by current' applies to allloads (linear or non-linear) at any given value of voltage.
Ohm's Law V = I R Voltage = Current x Resistance
No. Voltage divided by resistance is equal to current.
Ohm's law.
If resistance increases and voltage stays the same, then current decreases. Ohm's Law: Current equals Voltage divided by Resistance.
Ohm's Law. It is usually written as V = I x R or in words Voltage is equal to Current times Resistance; or in your terms I = V / R.
Similarly the OHM is said to be the HOME of the volt.
Ohm's Law.AnswerActually, Ohm's Law makes no mention of 'resistance', and the equation to which you refer is actually derived from the definition of the ohm, and not from Ohm's Law.Ohm's Law simply describes the linear relationship that exists between current and voltage in some, but not all, conductors.Incidentally, there is no such thing as a 'voltage difference' because voltage is synonymous with potential difference, so 'voltage difference' is the same as saying 'potential difference difference'!
I am not sure how the two objects of equal resistance are supposed to be connected. But for a current to flow, for example across a resistor, there must be a voltage difference between the terminals of this resistor.
Power, in 'watts'.
There is an electronic formula voltage/resistance = current If you translate this into plumbing terms voltage would equal water pressure resistance would equal pipes and valves and the current would equal the flow rate. If you start closing a valve it increases resistance and lowers the current flow
Voltage and current are two different things. Voltage is the electric potential difference between two points. Expressed in volts, it is also joules per coulomb. Current is the charge flow past a point. Expressed in amperes, it is also coulombs per second. You can relate voltage and current using Ohm's Law, which states that voltage is equal to current times resistance. Resistance is, therefore, equal to voltage divided by current. Using base units, resistance is equal to joules per coulomb divided by coulombs per second, which simplifies to joule-seconds per coulomb squared. That is a difficult unit to write, so we just use ohms as the unit.
No. V =Voltage, I =current, and R =resistancein the simple equation: V=I*R. As well, V/I=R, and. V/R=Iso Current is voltage divided by resistance