0
Cutoff voltage is the point at which the battery is fully discharged. This is usually the point at which the device will shut itself off.
What else can I help you with?
What is 0.37v and 0.63v in RC circuit?
0.63 is the knee voltage & 0.37 is the cutoff voltage
Why you take cutoff freqency at 3dB?
3 dB implies 1/2 the power and since the power is proportional to the square of voltage, the voltage will be 0,707 of the passband voltage. sqrt(0.5) = 0.707
What is meant by cut off voltage in diode?
Cutoff voltage is the point at which the battery is fully discharged. This is usually the point at which the device will shut itself off.
What are the voltage and current characteristics of a series circuit?
The voltage and current characteristics of a zener diode in the forward bias condition (anode more positive than cathode) are similar to an ordinary diode. Below the cutoff voltage, the current is near zero, excepting for leakage current. Starting at the turnon voltage, the diode starts to conduct. As voltage increases, current increases. At this point, increases in current result in very small increases in voltage. Above the breakdown current, the diode tends to self-destruct. The cutoff voltage for a silicon diode typically ranges from 0.6V to 0.7V, and the beginning of the flat region ranges from 0.7V to 1.4V, depending on the current rating of the diode. The cutoff characteristic is also highly dependent on temperature. It is important to understand that, while the current to voltage curve is relatively flat between the cutoff and breakdown points, it is not completely flat. This is normal diode behavior. In the reverse bias condition (anode more negative than cathode), the zener diode behaves very much like its forward bias condition, except that the cutoff voltage and flat region range are higher and, sometimes, flatter. This is what a zener is used for - it makes a good voltage regulator.
How does a stabilizer?
A home voltage stabilizer reduces (buck) or increases (boost) the out put voltage for respective increase and decrease in line voltage. To reduce output voltage the relay cutoff some transformer winding turns, and to increase output voltage the relay add some transformer winding turns in predefined steps.
How does a stabilizer works?
A home voltage stabilizer reduces (buck) or increases (boost) the out put voltage for respective increase and decrease in line voltage. To reduce output voltage the relay cutoff some transformer winding turns, and to increase output voltage the relay add some transformer winding turns in predefined steps.
Why transistorised inverters are prefered over thyristerised inverters?
The transistor allows you to turn it off when you want, while the thyristor, or SCR, will not turn off until the anode-cathode voltage drops below the cutoff voltage.
What happens to the cut off voltage if the brightness of the light is increased in a photoelectric cell?
The cutoff voltage depends on the maximum kinetic energy of the emitted electrons. The brighter the light the more photons released. which means more electrons released. each photon will release an electron with the same maximum kinetic energy whether the light is bright or dim. therefor the cutoff voltage remains the same if the brightness is increased
What college can you get for your cutoff?
what college will get for cutoff 170
What is early cutoff in auditing?
early cutoff
What cutoff did the donner party take?
They used the Hastings' Cutoff
When was Lucin Cutoff created?
Lucin Cutoff was created in 1904.
