The answer will depend on how much there is.
The answer will depend on how much there is.
The answer will depend on how much there is.
The answer will depend on how much there is.
The answer will depend on how much there is.
1900
1600Kg/m3
1950
2503.4
The density of course aggregate is 1560 km/ m^3. The density of something can be found by dividing the mass by the volume.
If by aggregate you mean the 'rock' mixed in to make concrete, then the density is usually about 2.7 g/cm3 .
This is the mass of aggregate that would fill a container of 1m3 capacity.
Add ballast that is less dense than the gravel/sand in the concrete such as LECA (Light Expanded Clay Aggregate).
fine aggregate zone classification codes
what is the density of 40mm coarse Aggregate
The density of course aggregate is 1560 km/ m^3. The density of something can be found by dividing the mass by the volume.
2.64
Objects whose aggregate density is less than the density of water float in it. Objects whose aggregate density is greater than the density of water sink in it.
If by aggregate you mean the 'rock' mixed in to make concrete, then the density is usually about 2.7 g/cm3 .
5
1400kg/m3
You convert everything to compatible units (volume should be in cubic meters or in liters), find the density of aggregate, and multiply the volume by the density to get the mass.
Use a higher density aggregate, or decrease the amount of air entrainment.
1.5 tonnes per Cubic metre.
It depends on 10mm what, and the density (or specific gravity) of whatever that substance is.
for desity test on aggregate as per procedure lay down