answersLogoWhite

0

What is fitting take off?

User Avatar

Anonymous

9y ago
Updated: 3/21/2022

Fitting take off is looking at plans and seeing how many valves ,tees ,and other fittings are needed for the proper installation

User Avatar

Jarrod Ruecker

Lvl 10
3y ago

What else can I help you with?

Related Questions

What is a fitting take-off?

Fitting take off is looking at plans and seeing how many valves ,tees ,and other fittings are needed for the proper installation


What is take off for 18 inch 45 degree fitting?

11 1/4"


What is the take off for a 10 inch 67 degree fitting?

9 15/16"


Where is the fuel filter on a 1974 nova?

It's usually in the carb. Take off the fuel line and unscrew the big fitting.


What is the take off measurement for a 8 inch victaulic 45 degree fitting?

The take-off measurement for an 8-inch Victaulic 45-degree fitting is typically around 7 inches. This measurement is used to determine the distance from the centerline of the fitting to the point where the pipe will be cut or connected. However, it's essential to consult the manufacturer's specifications or installation guidelines for precise dimensions, as they can vary slightly.


How do you take off Tran line from?

At the radiator, pop off the plastic cover and slide it back aways, then using a pick remove the "C" clip that is now exposed, once the clip is removed you can wiggle the line out of the fitting. Install the clip back into the fitting before you snap the line back in then slide the plastic cover back over the fitting.


What an 8 inch 90 degree pipe fitting take off when rolled 45 degrees?

Well, honey, when you roll an 8-inch 90-degree pipe fitting 45 degrees, you're looking at a take off of about 8 inches. It's simple geometry, darling. Just remember, always measure twice and cut once - ain't nobody got time for mistakes in the world of piping!


What is the take off for a 4 long radius victaulic 90?

The take-off for a 4-inch long radius Victaulic 90-degree fitting is typically around 4.5 inches. This measurement refers to the distance from the centerline of the pipe to the end of the fitting. It's essential to refer to specific manufacturer specifications for precise dimensions, as they may vary slightly.


How do you replace the front headlamp for 1986 Nissan pickup?

you must take the front grille off to get to the light ,remove 2 screws and fitting on light.


What do they do during a bra fitting?

They measure u with just ur bra on and sometimes they may tell u to take ur bra off to get a proper measurement


What is the take off measurement for 6 Victaulic 22.5 degree elbow fitting?

1-13/16"= The tangent of half the degree X the radius of the elbow.


What is the take off of a 8 inch 90?

The take-off of an 8-inch 90 refers to the measurement of the distance from the centerline of a pipe or duct to the edge of the fitting at a 90-degree angle. Typically, for an 8-inch duct or pipe, the take-off dimension can vary based on the specific design and manufacturer, but it is generally around 6 to 8 inches. This measurement is crucial for ensuring proper airflow and fitting in HVAC or plumbing systems. Always check manufacturer specifications for precise dimensions.