0
1st tension - 49-59 Nm.
2nd tension - 96-108 Nm.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why does water coming up by head Bolton 350 engine?
Water coming up by your head bolt (regardless of engine size) probably means you have a loose head bolt or a blown head gasket.
What is the Cylinder head bolt torque for 4JG2 engine of Isuzu bighorn?
What is the cylinder head bolt torque for isuzu bighorn.
WHAT IS THE HEAD BOLT TORQUE SETTING ON A TOYOTA 3L ENGINE?
What head torque for e
What is the head bolt torque for 1.6 Mazda protege?
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
What is the head torque for a John Deere 4239D engine?
head torque sequence, ft lbs, 4239d jd engine
What is the Head bolt torque for Nissan 2.7td?
The head bolts on the Nissan 2.7TD can vary depending on the engine. If the engine is a diesel cargo or serena, the cast iron head has about 80 foot-pounds of torque, but if it's a smaller petrol engine, the bolt head has a 60 foot-pound torque.
What is the head bolt tension of Mitsubishi 4D30 engine?
150 nm
How much does it cost to replace blown head gasket on 1998 Chevy Tahoe?
If it has a 5.3 engine, first have the cylinder heads pressure tested. Heads with a casting # of 706 like to crack in the number 1 head bolt hole. If this happens, replace head.
What is the Head bolt torque and valve lash on a 3304 caterpillar engine?
The head bolt torque, on a 3304 Caterpillar engine, is 350 pounds per square inch. The valve lash should be adjusted to .023.
What can cause little or no oil pressure to rocker arms when motor reads 40 lbs at idle?
What engine is it? In the old Ford 292 series it was a common problem to have the camshaft bearing "turn", blocking the oil line. The Chev inline 6 used a hollow head bolt that had to be in a specific position to allow pressurized oil to the head. If some other head bolt was put in that position there would be no oil pressure to the rockers. Check to see the routing of the oil pressure line to the head then backtrack to the most vulnerable position.
What is the head bolt Tension on a Toyota 1Z Engine?
40nm, 70nm, 113nm
What is the head bolt torque for 1989 mercury tracer 1.6 engine?
The 1989 Mercury Tracer 1.6 liter engine cylinder head bolt torque specification is 135 pounds. The cylinder head bolts should be torqued in 45 pound intervals.
