0
static head
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can a hot water heater pressure relief valve drain into a sewer line?
Not directly.
Why there is excessive water in air conditioner drain pan?
Drain line is clogged.
Why is your secondary drain line dripping?
Because the primary drain is either clogged or the pump is not working.
Can a sink drain and a washing machine share a stand pipe drain successfully?
No, stand pipe for washing machine is meant only for washing machine. Tie sink into drain line that washing machine stand pipe is tied into. 2" minimum drain line should be what you tie into. Sink drain line use 1 1/2".
What is the relationship between fluid head and pressure in a closed loop system?
Head = (Pressure * specific gravity)/2.31 Head in ft Pressure in pound per in^2
What is the difference between the hydraulic grade line and the energy line?
Hydraulic grade line is sum of Datum + Pressure Head Energy grade line is sum of Datum + Pressure Head + Velocity Head
Can a hot water heater pressure relief valve drain into a sewer line?
Not directly.
What happens to the temperature of the discharge line when the head pressure is increased?
the line go up
How do you drain power steering fluid on a 1987 Nissan pickup.?
Disconnect the low pressure line
Dose a positive pressure drain need a trap?
A trap on a positive drain is used to avoid the 'contaminated' air in a HVAC system from traveling through the condensate line and entering into areas where it is unwanted. The trap becomes necessary when one condensate line is used for multiple units, especially if it is tied to other negative pressure drain traps. The negative pressure drain traps may not drain properly if they have to overcome the positive non- trapped pressure of another unit. It allows the condensate to drain more evenly, as well. Without a trap, the positive pressure from the unit can blow air through the drain with the water and cause 'spitting.' A trap on a positive pressure system may not always be necessary, but it is good practice to trap every drain and trap it properly. There are guidelines for both positive and negative pressure traps. Always follow the manufacturers recommendations.
What is the difference between hydraulic grade line and energy grade lines?
Energy gradient line refers to total energy excluding the losses due to flow. ie) Datum Head + Pressure Head + Velocity Head Hydraulic gradient line refers to the line joining upper and lower water surface levels excluding losses and velocity head. ie) Datum Head + Pressure Head
Where is the water pressure regulator that is controlling head pressure be installed?
On the discharge line with the relief of the pressure control back to suction
How do you fix shower hot water when toilet is flushed?
Run a new cold supply line from the source. This will drain less pressure from the the cold shower line.
What is a condensate line in a furnace?
its the drain line for water to drain
How do you unclog an AC drain line?
There is a pan to collect the water. You could use compressed air to blow out the line, but you should take off the cover at the coil and clean the pan and coil. Also if you use compressed air, don't over do it. The pressure could blow off the drain line. You can use a product called Mighty Pump if the drain line comes out outside the home. You attach the Mighty Pump hose to the drain line and pump it a few times and it will suck out the line from the drain pan out which cleans the whole line. It has a lot of suction power and uses no electric. I
Is a shower head and taps center with the floor drain?
For aesthetic reasons, the shower head and taps are often in a line with the floor drain. I have never heard of any requirement that they must be so. It is usually most convenient to have the drain centered in the shower stall area, and the head is usually likewise centered, and a short run from the handles to the head is generally preferred, so yes, more or less.
Where is pt crusier condenser drain line located exactly?
The condenser does not have a drain line. The evaporator drain is on the lower passenger side of the firewall.The condenser does not have a drain line. The evaporator drain is on the lower passenger side of the firewall.
