Read about it : http://en.wikipedia.org/wiki/Lamp_(electrical_component)
Begin by removing the side indicator lamp connector. Take hold of the lamp, push in and turn at the same time. The lamp will come out.
The easiest way to reset the timing belt indicator lamp in your Toyota automobile is to remove the fuse for the indicator lamp. Keep the fuse out for approximately 30 seconds. Put the fuse back in and the indicator light should be off.
If the indicator lamp in a dry iron comes on when the iron is plugged into the power socket, but the iron does not heat up, it indicates that your iron has a problem with one of its electrical components.
To reset your malfunction indicator lamp start your car then you hire fps russia to blow up your piece of terrible car and buy a new one simple actually.feces
which one? front, rear, side?
Malfunction indicator lamp control circuit malfunction
If the the lamp is busted from impact, the filament would be burned out if the lamp was on at the time of impact. The position of the switch.
You need a blub or your brake fluid is low.
Yes, there is a lamp for the fuel. It is on the same line, where all other lamps are lokated, in the right end of the line.
The lamp out indicator, on your Dodge Ram pickup truck, suggests a headlight is not functioning properly. It can also refer to a turn signal.
it is an indicator. You need to check your brake fluid or your bulb.
P1700....Malfunction Indicator Lamp requested by trans control module