Want this question answered?
1meter
1. cutting tool should be more harder than the material to be cut otherwise it can break during the process. 2.cutting tool should be tough.well,there is much difference between the word hard and tough. hardness implies resistance to scratch whereas toughness measure ability to withstand shock. 3.The tool should be able to withstand the heat generated in the metal cutting process. Also, the tool must have a specific geometry, designed so that the cutting edge can contact the workpiece without the rest of the tool dragging on the surface of the piece part surface. The angle of the cutting face is also importantol must be able to withstand the heat generated in the metal cutting process. The angle of the cutting face is also important as is the flute width, tool margin and tool material. SUGGESTIONS ARE WELCOME
The cutting wheel is loose. Over tightening when you start can cause this. Cheap cutters do it quicker. Putting just enough pressure on the cutting wheel to make a groove until you make a couple of turns should keep the cutter lined up so that you can tighten the cutter.
At a minimum, the main step up transformer for a generator should carry 105% of the full MW output of the generator.
To save you and other from harm.
The minimum source-to-skin distance distance for a fixed fluoroscopy unit is 15 inches. For a portable x-ray machine, the minimum distance is 12 inches.
1meter
100
we should limit our cutting to a minimum
Neem trees don't have to be too far from the house. The minimum distance would be between seven and eight feet.
100 ft for every 10 mph.
Half the way
three truck lengths
The distance between the cooking range and sink on kitchen platform should be minimum 2 feets
1 meter = 3 feet
10 feet
127 mm for Indoor