Remove board and place horizontally on a waxed surface or waxed paper. Fill hole with spackling compound or putty using a putty knife. Tap brads (small nails) around perimeter of larger knotholes to hold putty. Choose pre-colored putty, or paint board when putty dries.
Silly putty is normally kept in a sealed container, if the silly putty has been left out and allowed to dry out completely then it is likely to shatter if dropped or hit with a heavy implement, such as a hammer.
at lime and lime inc.
You can make squishy putty by using borax, glue, and water! Mix a little of each together, add food colouring, and there you have it! Store in airtight container in fridge. Be careful, this putty stains!
Lime is a compound.
Slaked lime putty is a traditional material used up until the introduction of Portland Cement in the mid 1800s. It is still used in restoration work. It is a base for plaster walls, stucco, and mortar for brick work, where the final product depends on the additives used. Very fine sand and sometimes hair is added for interior plaster, where coarser sand is used in masonry.
When you slake a lime an leave it for a few months, there will be a layer of water (providing you used a sufficient amount) ontop of the slaked lime putty. this water is limewater and is clear but contains tiny particles in suspension. The putty is what we refer to as slaked lime.
an easy way to make putty is by using 1 part liquid starch to 2 parts of Elmer's glue slowly pour the starch into the glue and mix them together cover your putty and place it in the refrigerator for 6-8 hours before using
You could add lime putty. But the best solution would be to get a cement that sets in the amount of time you need, a 'slow setting cement'.
In lime based plaster, typically used to create beautiful interior polished plaster walls, or to create those gorgeous exterior walls seen throughout Europe, and higher end homes in North America, Limestone is the rock found in plaster. Limestone is created over millenia from fossilized sea shells. To create the plaster, the limestone is burned at very high temperatures and then slaked with water for anywhere from six months to ten years. The longer the slaking period, the better the quality of the "grassello" or lime putty produced. This lime putty is then mixed with marble flour to produce lime plaster.
Maybe mighty putty.
Putty is not clay.
Putty was invented to Secure the Networks.
plastic putty
You do not need to install PuTTY in Linux as there are built-in utilities that can do PuTTY's job (ssh, telnet)
silly putty was invented as a toy
Wall putty..