No, the transformer has to supply the load, whether it is light or heavy.
Because a transformer is a big lump of metal that takes time heat up, so if the load is on and off in a short time, the load rating can be exceeded.
Any transformer can be overloaded by applying a load above the capacity rating of the transformer.
No
It is a transformer with No load attach to it.
Hope this helpsAn "OFF-Load tap transformer" can only have it's tap adjusted when it is De-energized,while the "On-Load tap transformer" can adjust its tap under load conditions.Kind RegardsHammad KhanUniversity of Western AustraliaAnswerAn 'off load' transformer is one whose secondary is open circuited, and not supplying a load. An 'on load' (not 'load') transformer is one that is connected to a load.
No, the transformer has to supply the load, whether it is light or heavy.
A transformer is fundamentally a set of coils; therefore, a transformer is an inductive load. However, by "transformer load", you seem to mean "the load that is connected to a transformer". Whether that load is inductive or capacitive depends mostly on what is hooked up to the transformer.
Depends on the rating of the transformer and the running load of the houses connected to it.
Changing off-load tap changers requires opening up the transformer, draining (at least some) oil, and manually changing electrical connections. None of these things can be done while the transformer is hot.
Anything that draws energy from a supply is a load. So you 'load' a transformer by attaching a lamp, a motor, etc., to the transformer's secondary windings.
Tap changer is a device that is used to change the secondary voltage on transformers. It is normally on the HV winding of the transformer. Off load tap changer is designed to change the taps only when the transformer is not charged, while on load tap changer is capable of changing the tap on load too.
Because a transformer is a big lump of metal that takes time heat up, so if the load is on and off in a short time, the load rating can be exceeded.
Any transformer can be overloaded by applying a load above the capacity rating of the transformer.
A tap changer is used to vary the turns ration between the windings of a transformer to make minor changes to the secondary voltage. An on-load tap changer enables the turns ratio to be altered without disconnecting the transformer. An off-load tap changer requires the transformer to be temporarily diconnected. On-load tap changers are installed on the high-voltage side of the transformer, where the current is lower.
No. All a tap changer (whether 'off-load' or 'on-load') does is to make minor changes to the turns-ratio of a transformer.
A: a transformer will follow the rule of input output ratio with no load. As soon as a load is applied there will be changes in the ratio