The maximum amps for residential exterior light have different steps. One is having the service equipment like the main panel, entrance conductors, and meter base also having guidelines and code summary.
For typical residential application it is 20 amps.
If the mains is a 200 amp two pole breaker each leg can carry up to 200 amps in relationship to the common neutral of the service.
Each hot leg to the neutral wire of the service has the ampacity of 200 amps, that is why 3/0 wire is required. A 3/0 copper wire with an insulation factor of 90 degrees C is rated at 210 amps.
10 awg wire can have a breaker size of 30amps. It can actually carry more but as for codes the wire is usually allowed to carry 80% of its max capability which puts the breaker at a max size of 30 amps.
In normal residential use it is 20 Amps. That depends on alot of things such as the wire insulation, ambient temperature, etc. Standard NM 12/2 (Romex or equivalent, which is likely what you are asking as it is the primary type used to wire residential) is rated for 20 amps, 14 gauge is 15 amps, 10 gauge is 30 amps.
Maximum amps for chassis wiring : 101 amps Maximum amps for power transmission : 37 amps Reference : http://www.powerstream.com/Wire_Size.htm
no
depends on its use. If its for residential service its good for 125 amps In commercial and industrial installations it's a bit more complicated but you end up at the same 125 amps.
36.6 amps maximum at 120 volts, but should not be loaded to over 29 amps. At 240 volts it will produce a maximum of 18.3 amps but never loaded to any more than 14.6 amps.
depends on its use. If its for residential service its good for 125 amps In commercial and industrial installations it's a bit more complicated but you end up at the same 125 amps.
10 amps is the maximum it will carry.
ampacity is 1.3 Amps