answersLogoWhite

0


Best Answer

Original Somewhat Erroneous Answer:

The mcc room is the motor control room and is located in Canada

Correct Answer:

As stated above, a MCC is a Motor Control Center, and a MCC room is a room for Motor Control Centers. However, they are not always located in Canada. They can be found in many types of building with heavy motor loads. This includes factories, schools, hospitals, office buildings, convention centers, stadiums, etc.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is mcc room?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

What is MCC panel?

MCC (Motor Control Center) panel is used for distributing power to electric motors. mcc is made up of steel structure to contain the combination motor control units,wire ways,internal wiring and busbars.


What is means of MCC in substation?

It means Motor Control Center.


What is the difference between mcc and pcc?

MCC-Motor control center which consist of motor staters to control the motor. PCC-power contol center which is control the power to distribution system


How do you install shunt trip breaker?

A shunt trip breaker is installed like any other molded case breaker. The only difference is that it has an internal tripping coil that is usually connected to a C.T. The breaker is usually mounted in a MCC cabinet The top of the breaker is bolted to the MCC bus bars and the bottom of the breaker is connected to the load. The load conductors pass through the C.T.'s.


What is a stab in an electrical panel?

A stab is a way of connecting an external electrical device to a distribution bus bar. Stab lok breakers have a stab that connects the breaker to the bus bar by pushing the breaker into the bus bar and the breaker stab applies pressure in four directions to secure it. Another device that uses a stab is a module (bucket) that fits into a MCC (motor control center). These stabs are movable and are used to align the module to the bus bars. Using stabs on these devices allows for expansion and contraction of the bus bars when heavy loading generates heat. Also individual modules can be removed from the MCC without shutting the entire MCC off.