What is meaning of Transformer sensitivity?
The stability and sensitivity test shall be performed for unit protection to prove the stability for through fault and sensitivity for the internal faults. The principle of the test is as followed. The protected zone of unit protection is restricted by location of the CTs. For stability test the primary current shall be injected through one set of two CTs such a way one of current inwards and other outwards. At relay terminal no operating current shall be observed for proper connection. Sensitivity test shall be conducted with same set-up with either reversed CT polarity or injecting primary current on only one CT of the set. At relay terminal, operating current shall be observed for proper function.
Blowdown Valves In case of Transformer oil the meaning of BDV is break down voltage. It refers to the one of the tests of the oil.
Neither of these terms is normally applied to a transformer. You may be thinking of a 'mutual tranformer' and an 'autotransformer'. If so, then a 'mutual transformer' is a transformer which has electrically-isolated primary and secondary windings, whereas an 'autotranformer' (the term, 'auto', is misleading and has nothing to do with the transformer being 'automatic'!) has a common and series winding, meaning that the primary and secondary sides are electrically connected to each other.
It shows the Purification during the filtration of crude oil.
It is kind of transformers called center-tap transformer its main function is to transform primary voltage to 2 secondary voltages or vice versa. In your statement the transformer will convert the input voltage to 2 voltage each is 9v or the opposite it will convert the 2 input voltages with each 9v to a certain value depending on the turns ratio of the transformer.
Context?
Feedback can cause a lack of stability. However, negative feedback can actually reduce distortion, noise, and sensitivity to the noise.
An Oil Dielectric Strength Tester is the standard for qualifying Transformer Oil. Thermal Stability would involve heating and then testing. I do not know of a product which controls heat and applies the HV test.
The stability and sensitivity test shall be performed for unit protection to prove the stability for through fault and sensitivity for the internal faults. The principle of the test is as followed. The protected zone of unit protection is restricted by location of the CTs. For stability test the primary current shall be injected through one set of two CTs such a way one of current inwards and other outwards. At relay terminal no operating current shall be observed for proper connection. Sensitivity test shall be conducted with same set-up with either reversed CT polarity or injecting primary current on only one CT of the set. At relay terminal, operating current shall be observed for proper function.
Most people play on sensitivity 3-5, but alot prefer 4 for its quick control that still provides stability.
The meaning of organ sensitivity is the ability of an organ to respond to a particular stimulation. Some of the common organs in the human body include the heart, brain, kidney, liver and lungs among others.
Interpersonal sensitivity refers to the accuracy and/or appropriateness of perceptions, judgments, and responses we have with respect to one another.
Hypoalgesia
minimize congestion, stability margin improvement, line overload reduction, power flow control
Earthing of a transformer is done to 1:reduce the sensitivity of protective relays. 2:reduce the damage due to fault current. 3:get rid of great loss of equipment and money in case of any earth fault.
peace, prosperity and stability
The meaning of tender is gentle, kind and warm. However, it can also mean sensitivity in a certain part of the body where there is pain.