It means getting ready to go out.
"fitting to hit the block" likely means a situation where someone's actions or behavior indicate that they are likely to encounter obstacles or challenges in their endeavors. It suggests that the person is setting themselves up for difficulty or failure.
The main part of a prison is the cell block area, where inmates are housed in individual cells. This is where they spend most of their time when not engaged in activities or programs.
An action meant to harm or destroy is commonly referred to as an act of aggression or an act of violence. It can also be called an attack or an offensive action, depending on the context.
The surname Crump comes from England and meant "bent or crooked" and used to describe a cripple.
It seems like there is a typo in your question. If you meant to ask about "credible," it means able to be believed or trusted. A credible source is one that is considered reliable and trustworthy.
I accidentally hit my knuckle on the table while reaching for my keys.
When you jump up on the net and block the hit.
The fitting allowance is the difference: (pipe end to fitting center measurement) minus (pipe end to end measurement). It is the amount of length the fitting adds to the end of the pipe (to get the center of the turn).
You just have to hit it!!
The cervical cap
Under the fitting where the top radiator hose connects to the engine block.
Hit it with a sledge hammer.
expressionless eyes
The opposite of "block" as in impede is to unblock, or allow. The opposite of block (defensive move) is to hit (offensive move).
How to change thermostat: Drain coolant by removing drain plug on radiator. Locate lower radiator hose and follow it to engine block. Pull the hose from engine block to expose the fitting/thermostat cover. This fitting is held on with two 10mm bolts. Remove to expose thermostat.
You must mean the head not the block. Yes it can but use teflon tape.
Follow the hose from the top of the radiator to the metal fitting on the engine (should almost look like half a ball with a fitting the hose is attached to coming out at an angle). The thermostat is located under/between the fitting and the engine block. Drain coolant down several inches in radiator so it's below the level of the fitting. Remove hose/hose clamp from fitting, and 2 bolts from block. Seal SHOULD be a neoprene o-ring, so if it's in decent shape and not damaged/degraded, it can probably be reused, replace if unsure. Change thermostat, replace parts in reverse, and refill coolant in radiator.
get the block and hit the button with the block you got