answersLogoWhite

0

Proper termination of transmission line means to provide a circuit at the end of the line, often a resistor or an antenna, that matches the characteristic impedance of the line.

Incorrect or missing termination causes reflection of the signal back to the transmitter. In best case, you distort the signal. In worst case, you destroy the transmitter.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What types pf termination are used for single-ended cable for differential?

For single-ended cables used in differential signaling, common types of termination include series termination and parallel termination. Series termination involves placing a resistor in series with the signal line to match the source impedance, reducing reflections. Parallel termination, on the other hand, connects a resistor from the signal line to ground or the power supply, providing a path for reflections to dissipate. Both methods help maintain signal integrity and reduce crosstalk in differential transmission lines.


Is there a proper orientation for the splined knuckle on the drive shaft where it slides into the transmission of a 2001 s-10?

There is a proper way that the spindle slides into the transmission. The teeth on the spindle need to line up with the teeth on the transmission, if they are the proper mated parts this can be difficult to get in, sometimes shaking or wiggling parts while inserting helps.


What is meant by electrical phase?

according to my research a phase in electrical engineering means a single line or a single way of transmission


What is the transom of a boat?

a flat termination to a stern, above the water line.


How do you change transmission line?

how to fix a transmission without taking it a part how to fix a transmission line


You want to install a transmission cooler on a 2000 gmc sonoma v6 automatic and want to know which trans line is the in and which is the out at the radiator?

Look in the yellow pages under "Transmission Parts". Go to them and buy the proper cooler. They will show you the proper way to install the cooler. Do NOT use an auto parts store. (The top line is from the trans. to the rad., the bottom line is the return. Fluid flows downward in the radiator.)


What is meant by radial feeder?

In a power system, a "radial feed" is one where a source is only present at one end of the transmission line. If a source of power is present at both ends, it is said to be a networked line.


Do you get DC current directly from the transmission line?

Only if it is a DC transmission line.


Is there one coolant line or two for the transmission on a 98 Mercury?

If this vehicle has a transmission cooler then it will have one line to the cooler then another for the return line to the transmission.


How much does it cost to disconnect a line from an ATT contract?

The early termination fee is $175 per line.


Where is the fill line on L200 Saturn transmission?

The fill line for the transmission fluid on a Saturn L200 is typically located on the dipstick for the transmission. To check the fluid level, the engine should be running and the transmission in park or neutral. The fluid level should be between the "FULL" and "ADD" marks on the dipstick when the fluid is at the proper temperature. Always refer to the owner's manual for specific guidance related to your vehicle.


Will low pass filter works as transmission line?

No, but transmission line act as a lpf