The command ip classless is enabled on the router.
if a protocol is only classfull(RIPv1, IGRP) the command will have no effect, but in protocols that support vlsm and classless ip adressing it will enable the protocol to send the subnet mask in it's packets so that a router would not recognize only class networks, but also their subnets.
ip classless
the command block doesn't have an ip.
Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....
Supernetting
broadcast the packet through all interfaces except the one on which it was received
You go to command and type in ip config you should see everything to do with your ip there
The difference between classful IP addressing and classless IP addressing is in selecting the number of bits used for the network ID portion of an IP address. In classful IP addressing, the network ID portion can take only the predefined number of bits 8, 16, or 24. In classless addressing, any number of bits can be assigned to the network ID.
IP NAT Command is used to Exclude the IP from Routing Table or Tells the Router to fix the IP Static or exclude the IP from Route. used for Network Address Translation
On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing
From a command prompt, you can use the command "ipconfig" to display your ip address.