Its used in the compressors of refrigerators and air- conditioners
Crocoite is mainly used as a mineral specimen. It used to be used as a minor ore of chromium, but it is now too rare to be used for that.It is on wikipedia too
dilute ethanoic acid is used as a preservative in the preparation of pickles.it is used for making cellulose acetate which is an important artificial fibre.it is used in the manufacture of acetone and esters used in perfumes.it is used in the preparation of dyes.it is used to coaggulate rubber from latex.it is used for making white lead which is used as a white paint.it is used as a chemical reagent in chemistry lab.
evaporating is used in preparation of petrol, etc.
in what used lincomycin that is for what ?
oakum
Oliver didnt have a single sip of oakum.
Hemp
Oakum
oakum
Nope
Not enough packing or not tamped in enough. Possibly cracked pipe.
This may seem as a very odd answer, but technically, this horse type hair is called hemp in South Africa. It is used to join two metal pipes together to make a water or leak tight proof joint. The reasoning for it being called hemp and not another name is unknown and its orgins are also unknown. In the US, cast iron pipes, and this method of sealing them, has virtually disappeared, along with plumbers with the skill to do it. Although made from hemp, we call the rope/tar material oakum.
Hello I found this answer to the question... "How much oakum is required in 6 inch cast iron pipe before lead is poured into it?" From the Cast Iron Soil Pipe Association http://www.cispi.org/handbook/chapter4.pdf http://www.cispi.org/ Hope,this helps...
Oakum Picking, Stone and Bone Breaking, Gardening, Sewing, Cooking...
Cut out the old piping and caulk a new cast iron bell and spigot with lead and oakum and test
yes it can. kerosene lead melters were used by plumbers for many years. sewer drain lines were made of cast iron. one end of the pipe was a about half an inch larger than the od of the pipe. you put the pipe into the flared end of the next pipe and packed oakum down into the gap between them with a chisel leaving about half an inch from the top. then you poured molten lead in to fill up the rest of the space and used a special chisel and a hammer to drive the lead down on to the oakum and finish the seal. nowadays they use pvc pipe and glue. which is a whole lot easier.