There are isolation devices (Circuit breakers) meant to cut off or OPEN automatically when a fault occurs. The breaker has "opened" on fault.
Crack in the earth like in the movie the fault in our stars cracked ur heart open
Yes
Sorry, your fault if you opened your door into traffic. Even if you had it open for long enough that the approaching car had plenty of time to avoid hitting it.
Means the PCM has detected a fault with the closed loop system, and is operating in open loop fault. Open loop is a program that the PCM runs during start up, and continues to run until the PCM decides the o2 sensor is hot enough to be relied on for fuel control. closed loop runs relies on the o2 sensor for fuel control. open loop fault happens when an error is reported. look for O2 sensor DTCs.
The other driver's fault. He or she should have paid attention.Another View; IT DEPENDS. If you opened the door to a traveled lane and it was struck by passing traffic - YOU are the one at fault.
Probably because "fault" can be another word for "imperfection". So it was an imperfection in your memory that caused you to forget to close the window.
Technically it would be the fault of the person opening the door. You are not supposed to put parts of your car into the path of a car. Having said this, no accident is ever 100% someone's fault. In Wisconsin you are 10% at fault just for being there.
AnswerIf you were parked and you were exiting the vehicle (car not in motion), the other car is at fault. A parked car with door open or closed is still a parked car.AnswerThis MIGHT be a comparative negligence incident in which both of you may share fault. It depends on several factors: Was your door open all the way before the vehicle drove in? Did you open it the moment the car drove through? Was EITHER party paying attention?
Opening a door into traffic makes the door opener at fault. If the door is opened safely and some driver then runs into it, the moving driver is at fault.
To replace the wire ground fault switch, you need to switch off electric power from the source. After switching it off you can use the screwdriver to open screw and remove the faulty switch and replace it with a good one. <<>> There is no such a device as a ground fault switch. There is a ground fault breaker and a ground fault receptacle.
35 Cooling fan relay circuit open or shorted35 (trucks) idle switch motor fault - check connections35 Cooling fan relay circuit open or shorted35 (trucks) idle switch motor fault - check connections
An electrical breaker is a safety device used to open a circuit that has an electrical fault on it.