yes, it does
Cuz it can idiot
Because of surface tension on the top of the water. Surface tension is when the water molecules stick together allowing a small, light object to "float" on the surface. If you genitally pushed on the pin after is settled on the water, you would break the surface tension and the pin would sink.
Because the pin is more dense than the water. Density and weight aren't the same thing. A feather, for example, has less density than the water so it would float.
This happens because like us water has a skin and if you place a pin flat on the water and don't disturb the "skin" the pin will float as it is resting on the "skin" of the water, whereas, if you had to attempt to place the pin with the point facing down it will break/pierce the "skin" of the water and sink to the bottom and not rest on top because it experiences buoyancy which is more than its weight
yes, it does
Cuz it can idiot
yes it does because of the fizz giving it support but then after a while it sinks.
Because of surface tension on the top of the water. Surface tension is when the water molecules stick together allowing a small, light object to "float" on the surface. If you genitally pushed on the pin after is settled on the water, you would break the surface tension and the pin would sink.
Try checking your system settings, the box that it came in, or take it to an electronics store.
Check for the interface that is used to connect it to the motherboard using the IDE cables. If it is a 40 pin or 34 pin cable, then it will be an IDE interface device
It is a personal number used to identify a bank account, and is to be kept extremely secret. Most IC will have a dot or a mark or a tag TO IDENTIFY the pin 1 from the top pin 2 will be considered to be on your right sequentially clockwise
In The Show yes. In The Real Products No. But These Days With All The Electronics They Will Be Real Soon. But They Probably Wont Float
Yes the firing pin should float freely on top of the breech bolt. If you take the gun down (seperate the receiver) the firing pin will be visible, and should slide freely backa and forth.
The problem is most likely in the float bowl. The float could be bad. The likely cause is the needle valve that is control by the float is stuck, or dirt has gotten between the needle and needle seat. This is an easy fix. Carefully remove the float bowl. The float will be held in place by a pin. Remove the pin, and float. Check that there is no fuel in the float, and that it floats in gas, if not replace. The needle valve will come out with the float, as they are connected by a wire link. Make sure needle vale is clean, and able to move freely inside it's housing. Check the bottom of the housing at the needle seat to make sure it is clean of dirt. Reassemble, and you should be ready to go.
It is a special bolt/pin that allows the disc brake caliper to float. There is usually two per caliper.
Because the pin is more dense than the water. Density and weight aren't the same thing. A feather, for example, has less density than the water so it would float.