if you find out tell me what preload is
No, you don't need to mess with the rearend whatsoever when changing the driveshaft.
By replacing the front pads . they will reset automatically when the sensor sees the pads are ok.
Reset it with an OBD2 scan tool. If it came on after replacing the sensors you may have another problem. Reset it and see if it comes back on.
They are retained by the hub and bearing assembly. You must pull off the lockout hub and pull the bearings out, then the whol rotor and hub assembly will come off together, then to reinstall the bearing preload must be reset, it is not a job for the novice.
Reset light when replacing headlight
For Treos that do not have reset buttons, you can reset the phone by removing the battery and replacing it.
No. Already reset.
To reset the thermostat after replacing the batteries, locate the reset button on the device and press it. This will clear any previous settings and allow you to reprogram the thermostat with the new batteries installed.
To reset a smoke alarm after replacing the battery, press and hold the test button on the alarm for a few seconds until you hear a beep. This will reset the alarm and ensure it is functioning properly.
how to reset the batterie light
No reset is necessary.
There is a reset button on the front.