A: ZENERS are nothing else then regular diode that have a very predictable reverse breakdown voltage of xx volts. This voltage can be used to limit the input voltage or regulate on it.
Hi,
A rated breakdown voltage is the voltage that exceeds the designed voltage for a device. If for instance, a device has a rated breakdown voltage of 100 volts DC and you apply 200 volts, the odds are excellent that it will go into catastrophic failure, by either shorting out or creating an open circuit. Neither is desirable.
Hope this helps,
Cubby
when applied voltage is large ,the current flowing through insulation increases very sharply and electrical breakdown occurs
A strongly conuducting spark formed during breakdown .
This max.applied voltage called Breakdown volltage .
The breakdown voltage point for a Zener diode is 17 volts
because of its high break down voltage.
what is the difference between cut- in and cut -out
The dielectric material between the plates.
The Voltage of the power supply system is rated at its designed value. If this voltage goes down predetermined set value a under voltage relay can sense the change and then trips off the circuit.
The more voltage that is required to break down an insulator, the greater is its
The breakdown voltage point for a Zener diode is 17 volts
reverse voltage applied
Zener predicatively will break down at a voltage as manufactured and sustain that voltage as long as the source can provide the current. The limitation is the zener power dissipation for each device. It Regulates by maintaining that breakdown voltage until its current is reduced or its break down voltage is reduced.
A Germanium diode has a much lower breakdown voltage than a silicone diode.
In a reverse bias higher than the break down voltage.
because of its high break down voltage.
what is the difference between cut- in and cut -out
Rated voltage is the voltage at primary side. Rated current can be found from the equation, Rated Current= Output KVA / Output rated voltage
Peak reverse voltage of a diode is the maximum reverse bias voltage can be applied to diode which does not cause break down.
The breakdown voltage of an insulator is the minimum voltage that makes it partially conductive electrically. On the other hand, the breakdown voltage in a diode refers to the minimum reverse voltage to cause it to conduct in reverse.
If you exceed the rated voltage of your transformer, there is a high possibility that its insulation will break down and you will ruin that transformer.