You must mean output relay interface. Essentially, it's a circuit board with one or more relays used for switching electrical loads by another device such as a computer or programmable controller.
An output interface is a device that show information or data from a computer. Some examples of output devices are printers and monitors.
Yes. For sourcing output, the relay coil is wired to (common or ground) and the output terminal. For sinking output, the relay is wired to (voltage supply or hot) and the output terminal.
Data Output Interface
Gigabit Ethernet interface Controller interface Serial interface Multilink Group interface MFR (Multilink Frame Relay bundle interface) Dialer interface Loopback interface Tunnel interface ATM interface
From the output of the "show ip interface brief" command, you can see the IP address, interface status (up or down), protocol status (up or down), and the method for obtaining the address (manual or dynamic) for each interface on the device.
we want relay interface with 8085 and also attech the program
AN input-output interface is the piece of equipment or location at which information can be input and output from a device such as a computer. Examples of an input interfaces are: Command line, such as a DOS prompt. You manually enter in commands to achieve your results that you want. The keyboard is also part of this interface. A GUI (graphical user interface) is an Icon based interface and is much more user friendly and easier to use. (from a novice stand point) ;-) An output interface could be a printer a screen or a speaker.
Peripherals
AN input-output interface is the piece of equipment or location at which information can be input and output from a device such as a computer. Examples of an input interfaces are: Command line, such as a DOS prompt. You manually enter in commands to achieve your results that you want. The keyboard is also part of this interface. A GUI (graphical user interface) is an Icon based interface and is much more user friendly and easier to use. (from a novice stand point) ;-) An output interface could be a printer a screen or a speaker.
An I/O interface is a facility on a computer system for input and/or output of data. An example is a USB port on a PC.
generator lockout relay is a relay that the output of other relays energize this relay and its out put use for tripping of generator. this relay must be reset manually
LED interface requires typical 220 Ohm resistor in series While in case of relay resistor comes across coil with its value depends on supply voltage