0
What is required to remove water pump from 1994 Pontiac sunbird?
Wiki User
∙ 14y ago
tools and knowledge (or a manual)
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the water pump on a 1993 Pontiac Sunbird SE V6?
remove belt pump is accessable remove bolts make sure coolant is drained first replace
Where is your water pump on your 1994 Pontiac sunbird?
if its a 4 cylinder, its located inside the timing case.
How do you replace the water pump on a 1993 Pontiac Sunbird 4 cylinder?
Check autozone.com it tells a bit about it. some engines you have to remove the timing belt so its not a very east job.
Is the fuel pump relay switch in the trunk of a 1994 Pontiac Sunbird?
The fuel relay on a sunbird in under the hood on the left side just by the water over flow tank.
Where is the water pump located on a 1992 Pontiac Sunbird?
Look at the belt on the engine, then look at the pulleys. The water pump is behind the pulley without any groves in the pulley.
What lets hot water into the heater core on a 1993 Pontiac Sunbird?
The water pump pushes the coolant through the engine block and head(s) then into the heater core.
Is there a water gasket between the exhaust and engine block on a 1992 Pontiac sunbird 2.0?
No. There would be a gasket between the head and the block, though.
What would make a 1991 Pontiac sunbird overheat the water pump was changed and the cooling fan is working?
Stuck thermostat, clogged radiator.
Why is 92 Pontiac Sunbird taking on water inside?
heater core is shot. Take it to a shop, you don't want the headache involved in doing it yourself!
How do you replace the water pump on a 1992 Pontiac Sunbird 4 cylinder?
It dep[ends on exctly which engine you have as to how difficult it is, Get a manual you your car and do the job correctly .
How do you replace the water pump on a 1994 Pontiac Sunbird?
you undo the tire housing and pull off the exaust manifold. replace the muffler fluid and then your done
How do you replace the radiator on a 1999 Pontiac Montana?
Drain the water from the radiator. Remove the water hoses. Remove the retaining bolts. Reverse the process to install the new radiator.
