Equation for Equivalent Resistance in Series isReq= R1+R2+R3+...........If each resistor is equal to 3OhmsthenReq= R1+R2+R3Req=3+3+3Req=9 OhmsThe Equivalent resistance is 9 Ohms.
It is dc resistance, use to measure the rated current at primary and secondary side
Where V=stands for voltage, I=stands for current and R=stands for resistance. voltage=current multiplied by resistance so, by transposition, resistance=voltage divided by current. or R=V/I, R=9/3 The resistance is 3 ohms.as by ohm's law, v=irr = v/itherefore the resistance is 9/3=3 ohms
The combined resistance is 7.6049 ohms.
Wheatstone bridge is used to calculate the resistance of unknown resistor in the circuit.
Resistance - 2008 is rated/received certificates of: Australia:G
A lamp has two resistances: a 'hot' resistance (its operating resistance) and its 'cold' resistance (its resistance when switched off), and the hot resistance is significantly higher than its cold resistance.You can calculate its 'hot' resistance from its rated power and its rated voltage (assuming that it is being supplied at its rated voltage), by manipulating the following equation, to make Rthe subject: P= V2/RYou will, though, have to measure its cold resistance.
No, Hale does not appear in resistance 3 because that hale dies in the 2nd resistance after the final level. Resistance 3 will take control of Joseph capelli instead.
Earth the Resistance - 2014 is rated/received certificates of: UK:15
LG15 The Resistance - 2008 is rated/received certificates of: USA:TV-14
Noise and Resistance - 2011 is rated/received certificates of: Germany:12 (f)
Equation of Equivalent Resistance in Parallel is 1/Equivalent Resistance = 1/Resistance 1+ 1/Resistance 2 +1/Resistance 3If the resistance of the resistor is 3 Ohms then1/Req= 1/3 + 1/3 = 1/31/Req= 3/3Then cross multiply so3Req = 3Then isolate variable for Req (divide both sides by 3)answer1 Req= 3/3=1 OhmEquivalent Resistance is 1 Ohm
Resistance 3 is scheduled to be released on the 6th of September, 2011.
Resistance 3 is scheduled to be released on the 6th of September, 2011.
hello, i am actiually part of the PS3 team working on resistance and what i can tell you is that, yes we are currently starting work on a resistance 3.
Resistors are rated in ohms for their resistance value and in watts for the power they are capable of handling. They are not rated in volts or current.
The two most important ratings for an electrical heater are its rated power and its rated voltage, and these will be printed on a 'nameplate' fixed somewhere on the heater (e.g. '3 kW at 230 V').For the heater to operate at its rated power, it must be subject to its rated voltage. In the above example, the heater will only operate at 3 kW if it is supplied with 230 V.If you know the heater's power (P) and its voltage (U), then you can calculate the rated current (I) it will draw from the supply, using the equation: I = P/U.You can also determine its resistance (R), using the equation R = U2/P.