A shunt-trip coil is a built-in component of a shunt-trip circuit breaker. It is a magnetic coil that can be energized externally to make the breaker trip to shut off the flow of current.
For instance, fire sprinklers are sometimes required in the top of elevator shafts in case of a fire in the shaft. If the sprinklers were to spray water on the electric controls in the elevator cab, people could be hurt or killed, either from electrocution or from the elevator malfunctioning. In these cases, a shunt-trip breaker is installed in the circuit feeding the elevator controls, and the fire alarm system sends a trip signal if it detects waterflow from the sprinkler system. This trips the breaker and removes power from the elevator cab.
Once tripped, a shunt-trip breaker requires a person to reset it manually.
A secondary shunt releases (extra trip coil) is used forelectrical tripping of the circuit breaker by protectiverelays or manual control devices when more than onetrip coil is required.
Motor will rotate at very high speed leading to destructionAnswer from Kinindia.com
It is the resistance across the cell to invoke a constant draw. This makes the cell work efficiently under ideal conditions. To do it properly new cell management systems measure the temp. and voltage output and put a load on the cell that makes it work best.
.The magnitude of the voltage and current of both the armature and shunt field coil. To decrease the speed when the load is increasing then increase the shunt field current while decreasing the armature voltage or current. To increase the speed while the load is increasing then increase the armature current while decreasing the shunt field current. The decreasing and increasing of these currents and voltages can be done by connecting a variable resistor in series or parallel with each of the armature and/or shunt field coil.
DC shunt motor can be reversed by changing the polarity of either the armature coil or the field coil.
a shunt coil needs external supply & tripping coil gets supply from itself.
'Shunt' is an archaic term, meaning 'in parallel with'. So a 'shunt coil' is connected 'in parallel' with... With what, of course, depends upon what sort of device you are talking about. For example the field coil of a d.c. shunt-connected motor has its field winding connected in parallel ('shunt') with the supply.
shunt trip coil used to trip the breaker automatically or manually.
DC shunt motor can be reversed by changing the polarity of either the armature coil or the field coil.
220V
Yes, but you need a power source, for the shunt trip coil voltage, in the circuit.
An ammeter's coil requires very little current for full-scale deflection (fsd). So, to measure a current above its fsd value, most of that current must be allowed to bypass the coil. This is achieved by placing a very low value shunt resistance in parallel with the coil ('shunt' is an archaic word for 'parallel').
A secondary shunt releases (extra trip coil) is used forelectrical tripping of the circuit breaker by protectiverelays or manual control devices when more than onetrip coil is required.
I can only assume that you are attempting to connect 480VAC coil from a elevator to a fire system in order to shunt the elevator. In order to do this you will need a shunt trip breaker rated for this use.
Swap round the connections to the field coil or the armature, but not both.
Motor will rotate at very high speed leading to destructionAnswer from Kinindia.com
It is the resistance across the cell to invoke a constant draw. This makes the cell work efficiently under ideal conditions. To do it properly new cell management systems measure the temp. and voltage output and put a load on the cell that makes it work best.