a screw a tool and a margin is when you draw a line down your page of work
A: If an amplifier can be subjected to either input or output overdrive then clipping of both is desirable to insure safety margin and insure amplifier recovery in a minimum time
Transfer capability in transmission system defines the capability of system to reliably transfer power from one zone to other or from one part to other without affecting system stability. Under this concept there are various terms like Available transfer capability (ATC), total transfer capability (TTC), capacity benefit margin (CBM), TRANSFER CAPABILITY MARGIN (TCM). The term maximum transfer capability is termed as Total Transfer Capability means maximum power transfer from one part to another without violating system constraints.
the technique of curve fitting is used in many engineering streames and one of its important applications is that it is also used in industries to study the performance of the company and also to predit the future performence of the company. it very much helps in finiding out operational profit margin (OPM).
The emitter resistor places limits on the required gain, and temperature stabilizes the transistor. Without it, gain is hFe, but that is variable, temperature dependent, and subject to thermal runaway. With it, gain is predictable (collector resistor divided by emitter resistor, though limited by hFe), and temperature stabilized (so long as both resistors have the same temperature coefficient, and so long as the hFe margin is maintained).
One of the main advantages of using the emitter bias configuration has to do with the Q-points. With changes in the current gain, those Q-points don't change. Since the collector current accounts for 99% of the emitter current, we come up with a 1% margin of error, much better than the 5% we can get with the fixed-base bias configuration and Ic and Vce do not fluctuate as well.
They can be, and are, "skew". If they are not lines, they cannot be "skew lines".
There is no such thing as a skew plane - in isolation. It can only be skew with reference to something else.
No. Skew lines do not intersect
skew block plug
your face is a skew orthomorphic
No. Skew lines must be in different planes. Skew lines have no common points (they never cross).
Skew lines are non-coplanar, which means they are in different planes. Skew lines are in different planes and they do not intersect.
Answer is a skew lines do not lie in the same place
skew lines are noncoplanar lines, which means they aren't parallel and they also don't intersect skew lines do not intersect and are not coplanar
Skew lines never intersect. If two lines intersect, then they are known as "intersecting lines", not skew lines.
Skew Siskin - album - was created in 1992.
In linear algebra, a skew-symmetric matrix is a square matrix .....'A'