answersLogoWhite

0

What is specific load?

User Avatar

Anonymous

13y ago
Updated: 3/8/2023

Specific electrical loading is the insertion of impedance into a circuit to change the characteristics of the circuit. In contrast, specific magnetic loading is the ratio between the average flux air gap to the flux path of the air gap. These two terms have nothing to do with each other and are therefore independent of each other.

What else can I help you with?

Related Questions

What is the phase relationship of load voltage to load current?

that depends on the circuit. as you have not described it, no specific answer can be given.


Load a text in C language?

Where from? Where to? Be more specific.


What is a regulated firearm?

One that has been made and targeted with a specific load at a specific distance.


What is a good or bad specific gravity reading on a load of aviation fuel What specific gravity reading should I be looking for on a new load out of a tanker?

depends on the type of aviation fuel, need more info


What are udl loads?

Uniform Distribution Load Uniform Distribution Load


How do you calculate full load in single phase circuit?

The question has to be more specific. Full load amps, watts or voltage. Please restate your question.


Which insulated electrical wires match specific Amp loads?

All electrical wires are rated for specific amperage's. This is why conductors are matched to the load current so that a smaller size wire in not used on a heavy load current.


What is the difference between an electrical line and load in a circuit?

In a circuit, the electrical line carries the current from the power source to the load, which is the component that uses the electricity to perform a specific function. The line supplies power to the load, while the load consumes the power to operate.


What are point loads in engineering?

A point load is a load which is localized to a specific location on a structure. (Even though it is usually really not applied at a sharp point) The alternate kind of a load is a distributed load, which is pread accross a large area. For example, a pedestrian standing on a footbridge is considered a point load. Snow on the same footbridge is considered distributed load.


What is the ground snow load psf in Alberta Canada?

The ground snow load in Alberta, Canada varies depending on the location, but it is typically in the range of 20-30 pounds per square foot (psf) for residential areas. It is recommended to consult the National Building Code of Canada or local building authorities for specific information on snow load requirements in Alberta.


What is the snow load for Troy Montana?

The snow load for Troy, Montana can vary depending on the specific location and elevation within the town. It is recommended to consult local building codes or a structural engineer to determine the snow load requirements for a specific site in Troy, Montana.


What is the recommended 2x4 span chart for building a deck with a specific load requirement?

The recommended 2x4 span chart provides guidance on how far apart you should place the 2x4 boards when building a deck to support a specific load requirement.